Owner's Manual
Table Of Contents
- 1 Getting Started
- 2 Connecting
- 3 System Setting
- 4 Operating
- Home Menu Display
- Playing the Linked Devices
- General Playback
- On-Screen Display
- Advanced Playback
- Repeat playback
- Repeating a specific portion
- Playing from selected time
- Selecting a subtitle language
- Hearing a different audio
- Watching from a different angle
- Changing the TV Aspect Ratio
- Changing subtitle Code Page
- Changing the Picture Mode
- Viewing content information
- Changing content list view
- Selecting a subtitle file
- Listening to music during slide show
- Playing file encoded in 3D
- Advanced Features
- Using the Premium
- 5 Troubleshooting
- 6 Appendix
- Controlling a TV with the Supplied Remote Control
- Network Software Update
- Additional Information
- Audio Output Specifications
- Output status during playback according to Dolby Vision TV or HDR10 TV
- Area Code List
- Language Code List
- Trademarks and Licenses
- Specifications
- Maintenance
- Important Information Relating to Network Services
3 System Setting
System Setting 19
System Setting
3
Initial Setup
When you turn on the unit for the rst time, the
initial setup wizard appears on the screen. Set the
display language and network settings on the initial
setup wizard.
1. Press 1 (Standby).
The initial setup wizard appears on the screen.
2. Use W/S/A/D to select a display language
and press ENTER (b).
3. After checking the Terms of Service, select
[Agree] to use the Premium Service and SW
Updates.
Read and prepare the preparations for the
network settings and then press ENTER (b)
while [Start] is highlighted.
If a wired network is connected, the network
connection setting will automatically be finished.
4. All available networks are displayed on the
screen. Use W/S to select [Wired Network]
or desired SSID of wireless network and press
ENTER (b).
If you have security on your access point, you
need to input the security code as necessary.
5. Use W/S/A/D to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
6. Select [Next] and press ENTER (b) to apply
network settings. Network connection status is
displayed on the screen. For details on network
settings, refer to “Connecting to your Home
Network” on page 14.
7. Check all the settings that you have set in the
previous steps.
Press ENTER (b) while [Finish] is highlighted
to finish the initial setup settings. If there is any
settings to be changed, use W/S/A/D to
select 1 and press ENTER (b).