website : http://www.LGservice.com e-mail : http://www.LGEservice.com/techsup.
P roduct Feature Automatic Process From Washing To Drying. Automatic process from washing to drying can be selected easily. More Economical By Intelligent Wash System Intelligent Wash System detects the amount of load and water temperature, and then determines the optimum water level and washing time to minimize energy and water consumption. Direct Drive System The advanced Brushless DC motor rotates the drum directly without belt and pulley. Child-Lock TEMP.
I mportant Safety Information READ ALL INSTRUCTIONS BEFORE USE WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING : To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: • Read all instructions before using the washer.
S pecification Power Plug If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or a similarly qualified person in order to avoid a hazard. Drawer (For detergent and fabric softener) Control Panel Drain Hose Door Lower Cover Adjustable Feet Drum Drain Pump Filter Emergency Door Release Drain Plug Name Power supply Size : Front-loading Washing Machine : 120V~ 60Hz : 235/8 235/8 331/2 (inches) 600 600 850 (mm) Weight : 1561/2 lbs. (71 kg) Wash capacity : 1.
I nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. Shipping bolts The appliance is fitted with shipping bolts to prevent internal damage during transport. Removing shipping bolts 1.
I nstallation Installation place requirement Level floor : Allowable slope under entire washer is 1˚. Power outlet : Must be within 60 inches (1.5 m) of either side of the washer. Do not overload the outlet with more than one appliance. Additional Clearance : If the washer is installed inside a closet or alcove, the following clearances are required: 4 inches (10 cm) rear, 1 inch (2.5 cm) side Do not place or store laundry products on top of washer at any times. They can damage the finish or controls.
I nstallation Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3. Always unplug the machine and turn off the water supply after use. 4. Connect the machine to an earthed socket in accordance with current wiring regulations. 5. The appliance must be positioned so that the plug is easily accessible.
nstallation I Installation of drain hose ca. 40" max. 50" ca. 57" • When installing the drain hose at a sink, secure it so it cannot break away, causing flooding and damage. min. 23" ca. 41" • Proper securing the drain hose will protect the floor from damage due to water leakage. Laundry tub ca. 40" Hose Retainer min. 23" ca. 41" • The drain hose should not be placed higher than 40” above the floor. • Proper securing the drain hose will protect the floor from damage due to water leakage.
I nstallation Level adjustment 1. Leveling a the washing machine properly prevents excessive noise and vibration. Install the appliance on a solid and level floor surface, preferably in a corner of the room. Adjustable feet Higher 2. If the floor is uneven, adjust the adjustable feet as required. (Do not insert pieces of wood, etc. under the feet) Make sure that all four feets are stable and resting on the floor and then check that the appliance is perfectly level.
P reparation before washing 1. Care Labels Look for a care label on your clothes. This will tell you about the fabric content of your garment and how it should be washed. 2. Sorting To get the best results, Sort clothes into loads that can be washed with the same wash cycle. Water temperature and spin speed and different fabrics need to be washed in different ways. Always sort dark colors from pale colors and whites. Wash separately as dye and lint transfer can occur causing discoloration of white etc.
A dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer 3. The liquid bleach drawer. MAX • Do not open the detergent drawer during water fill cycle. • Bleach will be dispensed automatically after the detergent has had time to work. M A X max • Do not fill past MAX indicator. Detergent fot wash Fabric softener Liquid Bleach 2. Adding Fabric Softener Softener level MAX MAX 125 ml 125 ml • Do not exceed the maximum fill line.
C ycles Recommended cycles according to the laundry type Fabric Program Type COTTON Color fast garments (shirts, night dresses, pajamas...)and lightly soiled white cotton (underwear...) PERMANT Polyamide, Acrylic, PRESS Polyester QUICK Wash/Rinse Temp. (Option) Drying Load (Option) WARM/COLD Wash:141/3 lbs. AUTO (WARM/WARM, RINSE PLUS, (6.5 kg) (TIME, NO HEAT) HOT/COLD, EXTRA WASH Dry:65/ lbs. 8 COLD/COLD) (3.0 kg) WARM/COLD RINSE PLUS, (WARM/WARM, EXTRA WASH COLD/COLD) 65/8 lbs. (3.
H ow to use washer EXTRA WASH RINSE PLUS OPTION 1200 1000 800 600 400 NO SPIN RINSE HOLD SPIN AUTO TIME NO HEAT DRY HOT/COLD WARM/WARM WARM/COLD COLD/COLD TEMP. 1. For use in the initial p rogram (Cotton) • To start, press the POWER button. • Press the START/PAUSE button. • Initial condition - Wash Main Wash Only - Rinse 3 times - Spin 1200 rpm - Temp.
H ow to use washer EXTRA WASH RINSE PLUS 1200 1000 800 600 400 NO SPIN RINSE HOLD TIME NO HEAT OPTION SPIN DRY TEMP. (1) (2) (3) (4) (1) OPTION (2) SPIN (3) DRY TIME DELAY HOT/COLD WARM/WARM WARM/COLD COLD/COLD AUTO TIME LEFT (5) (4) WATER TEMP. (5) CHILD LOCK (6) TIME DELAY RINSE PLUS OPTION • By pressing the Option button, the wash type can be selected. - EXTRA WASH - RINSE PLUS - EXTRA WASH + RINSE PLUS • If the laundry is heavily soiled, Extra Wash course is effective.
H ow to use washer Dry AUTO • This washer-dryer’s automatic process from washing to drying can be selected easily. NO HEAT • For most even drying, make sure all articles in the clothes load are DRY similar in material and thickness. • Do not overload dryer by stuffing too many articles into drum. Items must be able to tumble freely. • If you open door and remove load before dryer has finished its cycle, remember to press the START/PAUSE button. TIME 1.
H ow to use washer Wash/Rinse Temperature. HOT/COLD • Press TEMP. to cycle through the WARM/WARM temperature choices. WARM/COLD COLD/COLD • Select a water temperature based on the type of load you are washing. Use the warmest water safe for fabrics. TEMP. Follow garment label instructions. • Warm rinses leave the loads dryer than cold rinses. Warm rinses increase wrinkling. In cold climates, a warm rinse makes the load mere comfortable to handle. Cold rinses save energy.
H ow to use washer P rogram Time Delay TIME LEFT TIME DELAY TIME LEFT TIME DELAY 1. Time Delay Preparing washing before starting Time Delay - Turn on the water tap. - Load laundry and close the door. - Place the detergent and fabric softener in the drawer. • How to set TIME DELAY - Press POWER button. - Press the PROGRAM button to select the program you require. - Press TIME DELAY button and set the desired time. - Press the START/PAUSE button. (The colon will blinks.
H ow to use washer Caution! Do not use the emergency release during wash. Door Lock • Shows when the door lock is active. • When the lamp is off or blink, the door can be open. DOOR LOCK Start/Pause START PAUSE Power 1. Start • This START/PAUSE button is used to start wash cycle or pause the cycles. 2. Pause • If temporary stop of wash cycle is needed, press START/PAUSE button. • After the pause button is pressed, the power is turned off automatically 4 minutes later.
H ow to use washer Display TIME LEFT 1. Special Function Display • When child lock is selected, is displayed. • When time delay is selected, it shows the remaining time to finish the selected program. 2. Self-Diagnostic Display • If the washer has a trouble, the trouble type is displayed.
M aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. The water inlet filter - No Inlet error message will blink on the control panel when water does not enter the detergent drawer. - If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is a good idea to clean it from time to time. 1. Turn off the water tap. 2. Unscrew the water inlet hose. 3.
M aintenance Dispenser Drawer ❋ After a while, detergents and fabric softeners leave a deposit in the drawer. max M A X MAX MAX • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pulling it out. • To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
M aintenance Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral, non-abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit the surface with sharp objects. ❋ IMPORTANT: Do not use methylated spirit, solvents or similar products. 2. Interior Dry around the washer door opening, flexible gasket and door glass.
T roubleshooting Guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you call the Service Department. Symptom Possible Cause Solution Rattling and clanking noise • Foreign objects such as coins or safety pins may be in drum or pump. Stop washer and check drum and drain filter.
roubleshooting Guide T Symptom Washer does not start Possible Cause • Electrical power cord may not be plugged in or connection may be loose. Make sure plug fits tightly in wall outlet. • House fuse blown, circuit breaker tripped,or a power outage has occurred. Reset circuit breaker or replace fuse. Do not increase fuse capacity. If problem is a circuit overload, have it corrected by a qualified electrician. Turn on water supply tap. • Water supply tap is not turned on.
T roubleshooting Guide Symptom Possible Cause Solution NO INLET • Water supply it not adequate in area • Water supply taps are not completely open. • Water inlet hose are kinked. • The filter of the inlet hose clogged. Check another tap in the house. Fully open tap. Straighten hose. Check the filter of the inlet hose. NO DRAIN • Drain hose is kinked or clogged. • The drain filter is clogged. Clean and straighten the drain hose. Clean the drain filter.
W arranty Visit our web site at http://www.lgservice.com LG Electronics LIMITED WARRANTY United States of America LG Electronics will repair or at its option replace, without charge, your product which proves to be defective in material or workmanship under normal use during the warranty period listed below from the date of original purchase. This warranty is good only to the original purchaser of the product during the warranty period as long as it is in the U.S including Alaska, Hawaii, and U.S.
P/No.
