Installation Guide

ManualsBrandsLG Electronics ManualsAppliance partsLaundry Pedestal with Storage Drawer in Wild Cherry Red

ENGLISH

for washer/combo

for dryer

for washer/combo

Lock nut

Adjustable feet Adjustable feet

Leg Extension

IMPORTANT: Read and follow these instructions.

NOTICE

The installer must have electrical and mechanical training and acceptable knowledge in the

required work.

Safety is foremost---both your own and that of other

people. Many important safety instructions are provided

in this instruction and your appliance. Always read and

observe all safety instructions.

Remove pedestal,installation hardware, and

instructions from the shipping carton.

Position the washer/combo on top of the pedestal.

WARNING

Excessive Weight Hazard

Two or more people may be needed to install and

move the appliance and pedestal assembly.

Do not allow children to play on the drawer.

Do not step on the handle.

A firm, solid floor is even more critical to a front-loading

washer than to a top-loader. If your floor is wooden

and /or frame construction, you may need to reinforce

it. Front-loaders have substantially faster spin speed

than top-loaders, causing greater vibration. If the floor

is not solid, your washer will vibrate.

WASHER/COMBO INSTALLATION

Before installing the pedestal, remove foreign

objects on the floor clean the floor. Dust, water, oil,

detergent and so on could cause vibration due to

bad contact of legs with floor.

After the washer is leveled, tighten the lock nuts up

toward the base of the washer using the wrench. All

four lock nuts should be tightened.

Level the pedestal on the clean place by adjusting

the feet.

NOTE

If a drip pan must be used, take extra care to follow

the instructions provided with the drip pan and make

sure the leveling feet are adjusted for firm and even

contact with the pan. Use of drip pans and failure to

properly level the machine may result in increased

vibration and noise during operation.

NOTE

Do not extend the legs no more than necessary to

level the washer. The more the legs are extended, the

more the washer will vibrate.

NOTE

Because of the weight of the washer/combo, two or

more people may be needed.

NOTE

If the washer or combo was previously installed,

unplug it, disconnect the inlet hose (s)from the faucet

(s), disconnect the drain hose, and drain all hoses.

NOTE

Summary of content (3 pages)

PAGE 1
IMPORTANT: Read and follow these instructions. NOTICE The installer must have electrical and mechanical training and acceptable knowledge in the required work. Safety is foremost---both your own and that of other people. Many important safety instructions are provided in this instruction and your appliance. Always read and observe all safety instructions. Level the pedestal on the clean place by adjusting the feet.
PAGE 2
Level the washer/combo on the pedestal by adjusting the feet. Move the washer/combo to the desired place. NOTE The appliance and pedestal assembly must be placed on a solid and level floor for proper operation. Adjust the legs of the appliance and pedestal by turning with a wrench. Then, adjust the lock nut toward the pedestal while holding the pedestal leg using a wrench.
PAGE 3
DRYER INSTALLATION Remove pedestal,installation hardware, and instructions from the shipping carton. Make sure the holes on the pedestal align with the holes in the appliance, then install 2 screws at each corner to securely attach the appliance to the pedestal. ENGLISH Insert the T-clip of the 4 retainers into the dryer base as shown. Press up on the back of the clip and pull outward to lock into place. NOTE If the screws are not installed properly, noise and vibration may result.