Troubleshooting Guide

48 TROUBLESHOOTING
Incomplete or no
dispensing of
detergent
Detergent compartments clogged from incorrect filling.
put into the correct dispenser compartments.
the dispenser drawer is fully closed before
the start of the cycle.
Too much detergent used.
dilute the detergent with water to the
maximum fill line on the compartment to avoid clogging. Use only HE (High-Efficiency)
detergent.
NOTE
detergent to achieve optimum results. Using too much detergent will cause poor wash and
rinse performance and may contribute to odors in the washer.
Insufficient water supply
ter faucets are turned on all the way.
Normal residue
of detergent to remain in the dispenser. If this residue
builds up, it can interfere with normal dispensing of detergents. Refer to the cleaning
instructions.
Washer will not
operate.
Control panel has powered off due to inactivity.
Power button to turn on the washer.
Washer is unplugged.
Water supply is turned off.
Controls are not set properly.
rrectly, close the door and press the Start/Pause
button to start the wash cycle.
Door is open.
closing completely.
Circuit breaker/fuse is tripped/blown.
on a dedicated branch circuit.
Start/Pause button was not pressed after the cycle was set.
Power button then reselect the desired cycle and press the Start/Pause button.
If the Start/Pause button is not pressed within a certain time, the washer will be turned
off. (The time varies by model, from 4 to 60 minutes.).
Extremely low water pressure.
adequate.
Washer is too cold.
es below freezing for an extended period of
time, allow it to warm up before pressing the Power button. Otherwise, the display will not
come on.
Problem Possible Cause & Solution