INSTALLATION 9 INSTALLATION ENGLISH Tools Needed Level Pliers Installation Overview Please read the following installation instructions first after purchasing this product or transporting it to another location.
10 INSTALLATION Product Specifications The appearance and specifications listed in this manual may vary due to constant product improvements. Electrical requirements 120 VAC @ 60 Hz Min. / Max. water pressure 20 – 120 psi (138–827 kPa) Dimensions 70 cm(W) X 77 cm(D) X 99 cm(H), 139.6 cm (D with door open) 27”(W) X 30 ¼”(D) X 39”(H), 55” (D with door open) Net weight 187.4 lb (85 kg) Max spin speed 1300 RPM WARNING ••Moving or installation of the appliance requires two or more people.
INSTALLATION 11 Choosing the Proper Location NOTE ••Before installing the washer, make sure the floor is clean, dry and free of dust, dirt, water and oil so the washer feet cannot slide easily. Leveling feet that can move or slide on the floor can contribute to excess vibration and noise due to poor contact with the floor. ••If a drip pan must be used, take extra care to follow the instructions provided with the drip pan and make sure the leveling feet are adjusted for firm and even contact with the pan.
12 INSTALLATION Unpacking and Removing Shipping Bolts Unpack all shipping materials from the washer for proper operation and inspect it for shipping damage. 3 Install the hole caps. Locate the four hole caps included in the accessory pack and install them in the shipping bolt holes. CAUTION ••Failure to remove shipping materials can cause excessive noise and vibration. 1 Lift the washer off the foam base. After removing the carton and shipping material, lift the washer off the foam base.
INSTALLATION 13 Connecting the Water Lines 1 Check the fittings and seals. Inspect the threaded fitting on each hose and make sure there is a rubber seal in place in both ends of each hose to prevent leaking. Rubber seal Water hose (to water inlet on washer) 2 Rubber seal Water hose (to tap) Connect the water supply hoses. Connect the water supply hoses to the hot and cold water faucets tightly by hand and then tighten another 2/3 turn with pliers.
14 INSTALLATION Connecting the Drain Hose Option 2: Laundry Tub Connect the drain hose to either a standpipe or laundry tub. 1 NOTE ••The drain hose should always be properly secured. Failure to properly secure the drain hose can result in flooding and property damage. ••The drain must be installed in accordance with any applicable local codes and regulations. ••Make sure that the drain hose is not stretched, pinched, crushed, or kinked.
INSTALLATION 15 Leveling the Washer NOTE ••Adjust the leveling feet only as far as necessary to level the washer. Extending the leveling feet more than necessary can cause the washer to vibrate. ••Before installing the washer, make sure that the floor is clean, dry and free of dust, dirt, water and oil so the washer feet cannot slide easily. Feet that move or slide on the floor can contribute to excessive vibration and noise due to poor contact with the floor.
16 INSTALLATION Connecting to the Power Supply The washer should be plugged into a 120-VAC, 60 Hz grounded 3-prong outlet. Plug in the washer. WARNING ••Do not use a worn or damaged power cord or power plug. Replace or repair it immediately. Failure to do so may result in death, fire, electric shock, or malfunction. ••Do not modify the power cord and plug provided with the appliance. Take care not to damage it when installing or moving the washer.