Manualshelf

Full Product Manual

ManualsBrandsLG Electronics ManualsAppliances27 in. 4.8 cu. ft. Mega Capacity White Top Load Washer, Agitator, with TurboWash3D and Wi-Fi Connectivity
21222324252627282930
22 OPERATION
• If the washer is running, use this button to pause the cycle without losing the current settings.
NOTE
• If the Start/Pause button is not pressed to start the selected cycle, after a delay the washer
automatically turns off and all cycle settings are lost. Any water remaining in the drum will be drained.
d Time and Status Display
e Cycle Modifier Buttons
• Use these buttons to adjust the wash temperature, spin speed and soil level settings for the selected
cycle.
• The current settings are shown in the display.
• Press the button for that option to select other settings.
f Option and Extra Function Buttons
• These buttons allow you to select additional cycle options. Certain buttons also allow you to activate
special functions by pressing and holding the button for 3 seconds.
Time and Status Display
a Estimated Time Remaining
• When a cycle is selected, the default time for that cycle is displayed. This time will change as modifiers
or options are selected.
• If the display shows
---, then the time will be displayed after the load sensing has detected the load
size.
• The time shown is only an estimate. This time is based on normal operating conditions. Several
external factors (load size, room temperature, incoming water temperature, etc.) can affect the actual
time.
NOTE
• Once the Start/Pause button is pressed, the washer will measure the size of the load. The estimated
time may change once the load size has been measured.
• If the Delay Wash function is set, the remaining delay time counts down until the cycle begins.
b Cycle Status Indicators
• These LEDs will blink when a cycle is selected to indicate which stages will run.
• When a cycle is running, the LED for the active stage will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the LED will turn off. If a cycle is paused, the active stage
LED will stop blinking.
c Door Lock Indicator
• This indicator lights up when the cycle starts and the door is locked.
• The indicator light stays on until the cycle is paused, stopped or has finished.
d Wi-Fi Indicator
• This indicator is lit when the product is connected to a home Wi-Fi network.