User's Manual

User Manual
PAGE :
DOCUMENT No. :
REG. DATE : 2020.04.09
MODEL NAME : ETWFAEWC01
REV. NO : v1.0
©2020 LGIT. All rights reserved.
9 / 7
REV. DATE : 2020.04.09
WC40154
10. FCC/IC Statement
Antennas list
This radio transmitter [ETWFAEWC01] has been approved by I
nnovation, Science and Economic Development Canada to op
erate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this
list that have a gain greater than the maximum gain indicate
d for any type listed are strictly prohibited for use with this d
evice. This module is certified with the following integrated a
ntenna.
-Type: External PCB Antenna
-Max. peak Antenna gain: 1.50dBi
Any new antenna type, higher gain than listed antenna shoul
d be met the requirements of FCC rule 15.203 and 2.1043 as
permissive change procedure. The use of a different trace lay
out other than approved requires a Class II Permissive Chang
e or a New Grant as appropriate.
End Product Labeling
The module is labeled with its own FCC ID. If the FCC ID is not vi
sible when the module is installed inside another device, then th
e outside of the device into which the module is installed must a
lso display a label referring to the enclosed module. In that case,
the final end product must be labeled in a visible area with the f
ollowing:
-Contains FCC ID: YZP-ETWFAEWC01
-Contains IC: 7414C-ETWFAEWC01
Le module
ETWFAEWC01est étiqueté avec sa propre identification
FCC et son propre numéro de certification IC. Si l’identification F
CC et le numéro de certification IC ne sont pas visibles lorsque l
e module est installé à l’intérieur d’un autre dispositif, la partie e
xterne du dispositif dans lequel le module est installé devra égal
ement présenter une étiquette faisant référence au module inclu
s. Dans ce cas, le produit final devra être étiqueté sur une zone
visible avec les informations suivantes : « Contient module émett
eur identification FCC ID : YZP-ETWFAEWC01-« Contient module
émetteur IC : 7414C-ETWFAEWC01
Information on test modes
and additional testing req
uirements
OEM integrator is still responsible for testing their end-product f
or any additional compliance requirements required with this mo
dule installed (for example, digital device emissions, PC peripher
al requirements, additional transmitter in the host, etc.).
Additional testing, Part 15
Subpart B disclaimer
The final host product also requires Part 15 subpart B compli
ance testing with the modular transmitter installed to be pro
perly authorized for operation as a Part 15 digital device.
Frequency Band WLAN(2.4GHz)(ETWFAEWC01)
WLAN(2.4GHz) 1.50dBi