User's Manual

User Manual
PAGE :
DOCUMENT No. :
REG. DATE : 2020.04.09
MODEL NAME : ETWFAEWC01
REV. NO : v1.0
©2020 LGIT. All rights reserved.
8 / 7
REV. DATE : 2020.04.09
WC40154
10. FCC/IC Statement
FCC Part 15.19 Statements: This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accep
t any interference received, including interference that may ca
use undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitat
ion est autorisée aux deux conditions suivantes : (1) l’appareil
ne doit pas produire de brouillage, et (2) l’utilisateur de l’appar
eil doit accepter tout brouillage radioélectrique subi, même si l
e brouillage est susceptible d’en compromettre le fonctionnem
ent.
FCC Part 15.21 statement Any changes or modifications not expressly approved by the party r
esponsible for compliance could void the user's authority to operate
this equipment.
<Regulatory notice to host manufacturer according to KDB 996369 D03 OEM Manual v01>
List of applicable FCC rule
s
This module has been granted modular approval as below listed
FCC rule parts. -FCC Rule parts 15C(15.247)
Summarize the specific op
erational use conditions
-The OEM integrator should use equivalent antennas which is the s
ame type and equal or less gain then an antenna listed in this instru
ction manual
RF exposure consideration
s The module has been cer
tified for integration into pr
oducts only by OEM integr
ators under the following c
ondition:
※1,2 Conditions of RF exp
osure considerations shoul
d be included in OEM man
ual and it should be inform
ed to an end-user.
1. The antenna(s) must be installed such that a minimum separatio
n distance of at least 20 cm is maintained between the radiator (ant
enna) and all persons at all times. -2. The transmitter module must
not be co-located or operating in conjunction with any other antenn
a or transmitter except in accordance with FCC multi-transmitter pr
oduct procedures. -Mobile use As long as the three conditions abov
e are met, further transmitter testing will not be required. OEM integ
rators should provide the minimum separation distance to end user
s in their end-product manuals.
l'exposition aux RF L’antenne (ou les antennes) doit être installée d
e façon à maintenir à tout instant une distance minimum de au moin
s 20 cm entre la source de radiation (l’antenne) et toute personne p
hysique. Caution: Any changes or modifications to this device not e
xplicitly approved by manufacturer could void your authority to oper
ate this equipment. Attention: Les changements ou modifications de
cet appareil non expressément approuvé par le fabricant peuvent a
nnuler votre droit à utiliser cet équipement.