Datasheet

S P E C I F I C A T I O N
PAGE :
DOCUMENT No :
REG. DATE : 10. 12. 16
MODEL : LEMWS59T75HZ00
REV. DATE : . .
REV.No : 0.0
(30)-4022
LGIT Confidential and Proprietary
©2010 LGIT. All rights reserved.
PRELIMINARY
14 / 18
10-2. Over-current-proof
Customer must apply resistors for protection, others slight voltage shift
will cause big current change ( Burn out will happen ).
LG Innotek will not be held responsible for any damage to the user that may
result from accidents or any other reasons during operation of the user’s
unit if use to exceed the absolute maximum ratings, or not keep the matters
that demand special attention.
10. Cautions on use
10-1.Circuit Layout
In general, the LEDs have a variation of forward voltage. Using LEDs with
different forward voltages in a circuit with on resistor for the complete circuit
causes different forward currents for each LED. This may lead to a variation in
brightness. To avoid brightness variation of LEDs, the use of matrix circuit with
one resistor for each LED is recommended.
10-3. For the Storage
- Proper temperature and RH conditions for storage are : 5 ℃ ~35 ℃ , RH 60%.
- Do not open moisture-proof bag before the products are ready to use.
- Store products in a moisture-proof bag with a desiccant(Silica gel) after open.
- These products should be used within 168 hours after opening the bag based
upon storage condition.
- These products must be baked to remove moisture before using them if the Silica
gel loses its color. Conditions for baking are 60±5℃, 20% (RH) and 24 hours
maximum. (For reeled status without bag)
- Considering the tape life, we suggest our customers to use our products within
a year(from production date)
10-4. Cleaning
- Please avoid using a brush for cleaning and do not wash the product in organic
solvents such as acetone, Organic solvent (TCE, etc..) will damage the surface
of LED. Please refer to following solvents and conditions.
Solvent : alcohol, 25℃ max × 600sec max