User's Manual

Confidential

LG Innotek

To wake Tag up from sleep mode, perform the following steps :

1. Put remote controller

near center of Tag display

2. Press and hold ‘Keep Alive’ button until Red LED off (about 0.5 seconds)

3. Tag will wake up and goes to next step. It’s depends on connection information with gateway

case1) If this Tag wasn’t connected with a gateway before sleep mode, go to 4-1

case2) If this Tag was connected with a gateway before sleep mode, go to 4-2

4-1. Searching gateway and goes to the next step. it’s depends on searching results

case1) If Tag was successfully connected, Tag’s display will be changed to “Ready”

case2) If Tag wasn’t connected, Tag’s display(may be “Ready”) will be refreshed

4-2. Sending ‘Keep Alive’ packet to gateway and Tag will go to sleep mode again

case1) If Tag was received response from gateway, this Tag will go to “sleep mode” until

the specified time in gateway. After “sleep mode”, this Tag will send “Keep Alive” Packet to

gateway again.

case2) If Tag wasn’t received response from Gateway, this Tag will retry three times. After that,

Tag’s display will be changed to “Disconnected” . Also this Tag will perform a whole channel scan

every five minutes.

4. Waking Tag up

Case 2

Case 3

☜