User's Manual

Confidential

LG Innotek

To make a Tag to be factory reset status, perform the following steps :

1. Put remote controller near center of Tag display

2. Press and hold ‘Reset’ button until Red LED off (about 0.5 seconds)

3. If Tag was received ‘Reset’ command from remote controller, Tag goes back to factory

settings and Tag’s display will be changed to “Ready”

4. After step.3, Tag goes to deep sleep mode and doesn’t communicate with gateway

until receiving ‘Keep Alive’ or ‘Registration’ data from remote controller

case1) If Tag was received “Keep Alive” or “Registration” command from remote

controller, this Tag will perform a whole channel scan.

case2) If Tag was received “Reset” or “Release” command from remote controller,

Tag’s display will be changed to “Ready” again

☜

☜☜

☜

5. Returning a Tag to be factory settings