Inside your life ! PoE Wi-Fi Bridge Manual (PoE: Power over Ethernet) [Model Name : TWFB-R101D ] 2015. 03. 06 .
1. Appearance Description for PoE Wi-Fi Bridge 1. Front Panel - The front panel has the 2-Button and status LEDs in the following figure. Button WPS • To connect WPS to AP(Access Point) WPS Reset • • Reboot Reset to Factory Default Reset LED Description Buttons LEDs Power POWER WLAN DATA CAMERA WLAN DATA CAMERA Fig 1. Front View Copyrightⓒ. 2015. All Rights Reserved.
2. Back/side Panel & Label Information - The back/side panels have the wireless antenna, power plug and 2-Lan ports. - The label on the bottom shows the MAC address, serial Number. Wireless Antenna AC 110V Power Label CAMERA (CAMERA LED) DATA (DATA LED) Fig 2. Back/side View Copyrightⓒ. 2015. All Rights Reserved. Fig 3.
2. Installation Guide 1. Log in connection Camera & Wi-Fi Bridge 1) Make sure that your camera is connected to the Wi-Fi Bridge CAMERA port with an Ethernet cable(wired) 2) Turn on the Wi-Fi Bridge and verify the following - The power LED is On. - The CAMERA LED is on for the LAN port that is connected to your Power device camera. - The WLAN LED is blinking. 3) Launch internet browser and enter http://172.19.1.254 in the address field. You are prompted to login; WLAN LAN Cable(CAMERA) CAMERA Fig 4.
2. Log in to the PoE 1) After entering http://172.19.1.254 , you can show Realtek WLAN AP webserver. Fig 5. Realtek WLAN webserver Copyrightⓒ. 2015. All Rights Reserved.
3. Wireless Site Survey 1) Please click “Wireless” in the webserver. 2) Please click “Site Survey” in the webserver( ①, ②), to fine AP list Click ② Click ① Fig 6. Wireless Site Survey Copyrightⓒ. 2015. All Rights Reserved.
4. AP Connection 1) After “Site Survey”, you can show AP lists. 2) Please select wanted SSID(AP Name) and click “Next” Click Fig 7. SSID Selection Copyrightⓒ. 2015. All Rights Reserved.
3) Please click “Connect” 4) After “Connect” click, You can show ”Please Wait” message 5) It will be connected. Please click ”Reboot Later” 6) Finally, Please close your web browser. Click Click Fig 8. SSID Connection Copyrightⓒ. 2015. All Rights Reserved.
3. Regulation Information INFORMATION TO THE USER This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
4. Regulation Information (French) Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
5. Appendix 1. WPS Function - You can use WPS to connect AP without any password(WPA or WPA2). ① Push AP’ WPS button. WPS ② Push PoE’ WPS Button(During 3 secs). Reset ③ When try to connect AP, WLAN LED is pulsing RED. ④ After connect AP, WLAN LED is blinking Yellow Green. If you didn’t push PoE’ WPS Button within 2min, It will be disconnected. * Notice - If you want to use WPS function, your AP must have WPS function. 2. Reset Function - If you push RESET Button for 3secs, the PoE will restart. 3.
4. PIN mode WPS Function of webserver ① Please click “Wireless” in the webserver. ② Please click “WPS” in the webserver. ③ If you use PIN mode WPS, first input Self-PIN Number to AP. After that click Start PIN. ④ Click ok. Click ① Click ② Click ④ Click ③ Copyrightⓒ. 2015. All Rights Reserved.
5. PIN mode WPS Function of webserver ① Please click “Wireless” in the webserver. ② Please click “WPS” in the webserver. ③ If you use PBC mode WPS in webserver, first push the WPS button of AP. After that click Start PBC. ④ Click ok. Click ① Click ② Click ④ Click ③ Copyrightⓒ. 2015. All Rights Reserved.