LG Motorsports 1211 Hwy 78 South Wylie, TX 75098 972-429-1963 www.lgmotorsports.com sales@lgmotorsports.
Required Tools: Fuse Removal Tool (In Fuse Panel:See Figure 10) 10mm Socket & Ratchet 7mm Nut Driver T15 Torx Driver Flathead Screwdriver T25 Torx Driver Disassembly: In order to install the new Man Switch Knob, you must first remove some of the panels from the interior of your car to route the necessary wires. First you must loosen the parking brake leather boot. This piece is held on with 2 retaining clips. To loosen the boot, simply grab the bottom of the boot towards the front and pull up.
Figure 2 Figure 3 Now it is time to remove the stock shift knob. To start, you must first loosen the leather shifter boot from the knob by turning the chrome trim ring counterclockwise and then pulling it down. (See Figure 4). Pulling the boot down around the shift lever will expose the T25 Torx screw (See Figure 5) that fastens the shift knob to the shift lever. Using the T25 Torx Driver, remove the screw and remove the knob from the lever.
Figure 7b Once the two screws and two nuts are removed, you need to lift the rear portion of the center console up and move it back. This may require a bit of finagling but now you need to loosen the front portion (The portion with the shifter boot, cup holder, stereo surround etc…) First pull up on the rear and then pull back on the entire piece and it should come unsnapped from the dash. Once the console is loose you will need to unplug all of the accessories.
Assembly: Now that you have the center console out of the vehicle, it is time to route the wiring for the man switch knob. You will start by pulling down the fuse panel cover in the front of the passenger side foot well (See figure 9).
I hope you will find our cockpit adjustable exhaust switch to be as enjoyable as we have. Again, thank you for your purchase with LG Motorsports. Please feel free to call or email us anytime with your corvette needs.