User Manual

Figure 2 Figure 3
Now it is time to remove the stock shift knob. To start, you must first loosen the leather shifter boot from the
knob by turning the chrome trim ring counterclockwise and then pulling it down. (See Figure 4). Pulling the boot
down around the shift lever will expose the T25 Torx screw (See Figure 5) that fastens the shift knob to the
shift lever. Using the T25 Torx Driver, remove the screw and remove the knob from the lever.
Figure 4 Figure 5
Next, you will need to remove the center console in order to route the wiring for your new knob. To do this you
must first open the console lid and remove the screw covers (See figure 6). This step may require the use of
the flathead screwdriver, but most likely you will be able to remove these with your fingers. Next you will need
to remove the two screws from the front of the compartment using the T15 Torx Driver, and the two nuts in the
rear of the compartment with the 10mm socket and ratchet. (See Figures 7a & 7b).
Figure 6 Figure 7a