Installation Manual

ENGLISH
40
Use Default
• If you want to use default password(this password was generated randomly), you must select ‘Enable’ in this item.
Security Key
• If you want to change default password, you need to change ‘Use Default’ value into ‘Disable’.
Wi-Fi Signal Strength
• You can control wireless signal strength on SoftAP. This is controlled by 5 step. If you select ‘Not Used’, wireless signal strength will be set to Max
value.
Wi-Fi Channel
• You can control wireless channel on SoftAP mode. This is controlled from 1 to 11 channel. If you select ‘Auto’, wireless channel of SoftAP will be
set to random channel.
Mode
(Depending on model)
• You can select NAT(Network address translation) mode and BRIDGE mode for Soft AP.
Security Type
(Depending on model)
• You can select ‘WPA2-PSK’, ‘WPA2-Enterprise’ and ‘Open’ if you selected ‘BRIDGE’ mode.
Radius Server IP, Radius Server Port, Radius Server Key
(Depending on model)
• You should enter Radius Server information if you selected ‘WPA2-Enterprise’.
VLAN ID
(Depending on model)
• SoftAP VLAN ID is needed when you want to separate TV packets and SoftAP packets.
• The packets via SoftAP are tagged when the packets go through LAN port to external network.
• It is not compatible with Network VLAN ID. (SoftAP VLAN is not available if LAN port or AUX port in VLAN ID is set.)