Manual

EXTERNALCONTROL THROUGH RS-232C

The RS-232C port allows you connect the RS-232C input jack to an external control device (such as a computer

or an A/V control system) to control the TV's functions externally.

01_Note: RS-232C on this unit is intended to be used with third party RS-232C control hardware and software.

The instructions below are provided to help with programming software or to test functionality using telenet

software.

RS-232C Setup

Type of Connector; D-Sub 9-Pin Male

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii] ii

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii i ii i i i i i i i i i i i i i i i i

No connection

RXD (Receive data)

TXD (Transmit data)

DTR (DTE side ready)

GND

DSR (DCE side ready)

RTS (Ready to send)

CTS (Clear to send)

No Connection

@ @

Communication Parameters

,l_Baud rate : 9600 bps (UART)

01_Data length : 8 bits

,l_Parity : None

,l_Stop bit : 1 bit

,l_Communication code : ASCII code

01_Use a crossed (reverse) cable.

-O

113