Installation Manual

206-4298

* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.

EZ-Manager Wizard (Cont.)

(Continued from previous page)

RF Conguration

a) In the Media Type eld, use the Left/Right arrow keys to select RF.

b) In the Data Channel eld, use the Left/Right arrow keys to select the RF channel number

that will be used by the Pro:Centric server as its data channel. The Data Channel value can

be set from 1 to 135. *

IP Conguration

a) In the Media Type eld, use the Left/Right arrow keys to select IP.

Note: When you select “IP” as the Media Type, the default RF Data Channel and Signal

Strength/Quality elds are replaced with IP Address and IP Port elds.

b) Enter the Pro:Centric server IP address and port number in the IP Address and IP Port elds,

respectively. The IP address must match the IPv4 multicast address and the port number

must match the port number that is set in the Pro:Centric server.

For each data entry eld: Use the arrow keys to select the eld and press OK. Then, you

can either use the number keys on the Installer Remote to direct enter data values, or you

can use the arrow keys to select the appropriate number(s) from the pop-up virtual keyboard

displayed at the bottom of the screen. When you are done, select Enter from the virtual

keyboard, and then press OK on the Installer Remote.

4. Once all elds are completed as required, you have two options:

• To save the data entered and exit the wizard, use the arrow keys to select EXIT and then press

OK. In the subsequent pop-up conrmation window, select SAVE & EXIT, and then press OK

once more. The Pro:Centric application and/or E-Z Installation data will be downloaded to the

TV at a later time. This option is useful, in particular, if the Pro:Centric server has not yet been

congured.

• To initiate a real-time download of Pro:Centric application and/or E-Z Installation data, use the

arrow keys to select SEARCH and press OK to verify the conguration data provided in step 3.

When the data is veried, the “SEARCH” button becomes a “NEXT” button. Select NEXT and

press OK to continue (see also note below).

Note: With RF conguration, Pro:Centric server data must be present on the RF channel

selected as the TV’s Data Channel in order for you to select “NEXT” (you will see a “data

channel found” message below the Signal Quality indicator). With IP conguration, Pro:Centric

server data must be present via the wired LAN cable connection in order for you to select

“NEXT” (you will see a “IP server found” message below the IP Port eld).

If you opt to initiate a real-time download in the last step, the EZ-Manager Wizard will proceed with

the Pro:Centric application and/or E-Z Installation data downloads (see Processing the Pro:Centric

Conguration screen example on page 18). When the Pro:Centric conguration is complete, an

EZ-Manager Conguration Complete screen (see example on page 18) is displayed, and after 10

seconds, the wizard exits, and the TV turns OFF.

Note: With the EZ-Manager Conguration Complete screen on display, you can also manually turn

off or reboot the TV. If desired, select TURN OFF or REBOOT, respectively, and then press OK on

the Installer Remote.