Installation Manual

206-4298

EZ-Manager Wizard (Cont.)

USB Conguration

TV Manager / USB download options enable you to download conguration or software les

individually from a USB memory device to the TV. You can also use the Ez Download utility

available from the menu to select one of each type of le to be downloaded at one time using

one process.

Each of the USB download functions requires that you have the appropriate le(s) loaded on a USB

memory device. If you wish to perform a software update or download a splash screen image, the

software update/image le(s) must be stored in a folder named “LG_DTV” in the root directory of the

USB memory device. Clone/Conguration (.tlx) les should simply be stored in the root directory of

the USB device.

The procedure below assumes the desired le(s) is/are already loaded onto the USB device. For

further information on the TV Manager / USB download options and le requirements, and/or for

information on creating Clone/Conguration (.tlx) les, refer to the appropriate section(s) in this

document.

Before You Begin

• If you intend to use the Zoning feature(s) on this TV, make sure to assign the appropriate TV

Zone # and/or Wi-Fi Zone # in the EZ-Manager’s Zones, Label, and Room Number screen

BEFORE continuing with USB Conguration. See “TV Conguration Options” on page 15 for

further information.

• Ensure the USB device to be used has been formatted with FAT format.

• When creating les to be downloaded, avoid using special characters (?, &, @, etc.) in lenames.

• Refer to “Ez Download Utility” on pages 32 to 35 for further information on the Ez Download utility.

• Refer to “Custom Master TV Setup” on pages 47 to 49 for information on creating a Clone (.tlx)

file, and/or refer to “Creating an FTG Conguration File” on pages 56 to 57 for information on

creating an FTG Conguration (.tlx) le for FTG Mode conguration.

• See Reference section, “Downloading a Splash Screen Image using a USB Memory Device,”

for splash screen image guidelines.

• See Reference section, “Updating TV/PTC Software using a USB Memory Device,” for further

information on software updates.

USB Conguration via EZ-Manager Wizard

With either the TV Conguration Options or the Zones, Label, and Room Number screen on display,

proceed as follows to congure the TV using the USB memory device.

1. Insert the USB memory device with the appropriate le(s) into either of the TV’s USB ports.

2. Use the arrow keys on the Installer Remote to select USB CONFIGURATION, and then press

OK.

You will be redirected to the TV Manager / USB download options (see example below).

(Continued on next page)