Installation Manual

25
206-4298
Express Script (Cont.)
(Continued from previous page)
1. In the Pro:Centric Mode eld, use the Left/Right arrow keys on the Installer Remote to select
the appropriate Pro:Centric Application Mode—FLASH, GEM, HTML, or CONFIGURATION
ONLY.
Note: For remote management only, select CONFIGURATION ONLY. The TV will search for
TV E-Z Installation data downloads; however, Pro:Centric application data will not be downloaded,
i.e., Installer Menu item 098 PRO:CENTRIC will be set to 0.
2. Refer to the appropriate subsection below, depending on the Pro:Centric server conguration, to
complete the remaining elds.
RF Conguration
a) In the Media Type eld, use the Left/Right arrow keys on the Installer Remote to select RF.
b) In the Data Channel eld, use the Left/Right arrow keys to select the RF channel number
that will be used by the Pro:Centric server as its data channel. The Data Channel value can
be set from 1 to 135. *
IP Conguration
a) In the Media Type eld, use the Left/Right arrow keys on the Installer Remote to select IP.
Note: When you select “IP” as the Media Type, the default RF Data Channel eld is replaced
with IP Address and IP Port elds.
b) Enter the Pro:Centric server IP address and port number in the IP Address and IP Port elds,
respectively. The IP address must match the IPv4 multicast address and the port number
must match the port number that is set in the Pro:Centric server.
For each data entry eld: Use the arrow keys to select the eld and press OK. Then, you
can either use the number keys on the Installer Remote to direct enter data values, or you
can use the arrow keys to select the appropriate number(s) from the pop-up virtual keyboard
displayed at the bottom of the screen. When you are done, select Enter from the virtual
keyboard, and then press OK on the Installer Remote.
3. Once all elds are completed as required, you have two options:
• To proceed with TV conguration via the Express Script, select NEXT and press OK on the
Installer Remote. Continue to “Complete the TV Conguration” on the following page.
• To save the data entered and exit the Express Script, use the arrow keys to select DONE and
then press OK on the Installer Remote. Remember, however, that if you do not complete the
Express Script, pillow speaker functionality will not be enabled unless you set Installer Menu
item 027 HOSPITAL MODE appropriately. See the “Installer Menu” section of this document
for further information.
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.