Installation Manual

206-4298

• If the Target TV is currently in Pass-through Mode and you intend to use the TV’s Zoning

feature(s)—i.e., the Clone/Conguration (.tlx) le you are importing contains an FTG Channel

Map and/or FTG prole(s) with TV Zone and/or Wi-Fi Zone assignments—make sure to assign

the appropriate TV Zone # and/or Wi-Fi Zone # in the TV when directed to do so in the procedure

below. See Reference section, “Using the TV’s Zoning Features,” for further information.

• If you would like the Target TV(s) to remain in Pass-through Mode after the Clone/Conguration

(.tlx) le is imported, ensure the “.tlx” le does not contain an FTG Channel Map; otherwise, the

import procedure will result in the Target TV(s) being congured for FTG Mode.

• If a Clone (.tlx) le (exported Master TV Setup) contains an FTG Channel Map, the physical RF

channels in the FTG Channel Map have been assigned logical channel numbers (see “Exporting

a Clone File” above). When you import the Clone le with the FTG Channel Map on the Target

TV(s), you will have the option to select either logical or physical channel tuning. Even if you

select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will

remain in logical order.

• If an FTG Conguration (.tlx) le (created in the FTG File Manager) contains an FTG Channel

Map, each logical channel number in the FTG Channel Map has been assigned a physical RF

channel, an IP channel, or an Aux input (the latter designated by 130-0 through 137-0—see also

Reference section, “TV Aux Input Conguration”).

Note: If the FTG Channel Map includes RF channels and Aux inputs only, when you import

the FTG Conguration le on the Target TV(s), you will have the option to select either logical or

physical channel tuning. If you select physical channel tuning, the physical RF channels and

Aux inputs in the FTG Channel Map will remain in logical order. Physical channel tuning is not

available when the FTG Channel Map includes IP channels.

• If the Clone/Conguration (.tlx) le was edited/created in the FTG File Manager, it may contain

multiple zoned FTG Installer Menu proles for different TV models. Make sure it includes the

appropriate Installer Menu prole(s) for the Target TV(s) before performing the procedure below.

Caution: Do not unplug the TV power cord or remove the USB memory device while

importing is in progress, as doing so may cause the TV to malfunction or harm the

USB device, respectively.

Import Clone File Procedure

1. Turn ON the Target TV.

2. The next step depends on whether the LG Setup Wizard appears on the screen when you turn

ON the TV:

• If the wizard is displayed, you can complete the import procedure via the EZ-Manager Wizard,

as indicated above (see “Before You Begin”). However, to continue with this procedure and

access the “Import Clone File” option from the TV menus, exit the Setup Wizard. Then, con-

tinue with step 3.

• If the wizard is not displayed, go directly to step 3.

3. If applicable (see also “Before You Begin” above), make sure to assign the appropriate Zone

designation(s) in the Target TV at this time.

Cloning Procedures (Cont.)

(Continued on next page)