Installation Manual

66
206-4298
IP Environment Setup (Cont.)
Pro:Centric Setup
Pro:Centric options enable you to congure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between elds.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the Pro:Centric menu option. Then,
press OK.
2. Select/highlight the Media Type eld and press OK on the Installer
Remote to display the drop-down list of options. Then use the Up/
Down arrow keys to select either RF or IP, as applicable.
Note: If the Media Type has already been set in the EZ-Manager
Wizard, the specied value will be reected in this eld.
Note: By default, the Pro:Centric Menu shows RF conguration
elds initially. When “IP” is selected as the Media Type, IP Address
and Port Number elds appear on the screen (in place of the Data
Channel eld).
3. Refer to the appropriate subsection below to congure the TV’s
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature (see
step 4), the appropriate Pro:Centric server conguration must be
completed to enable TV E-Z Installation (splash screen, conguration,
and software/rmware) data downloads and, if congured, the
Pro:Centric application download.
RF Conguration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is left at its default value
(AUTO), the TV’s Data Channel Auto Search feature will be enabled. See Installer Menu item
119 DATA CHANNEL description on page 46 for further information.
• To toggle between AUTO or MANUAL settings for the Data Channel, select/highlight the
Data Channel eld and press OK.
• When the Data Channel eld is set to “MANUAL,” a data entry eld is available on the
screen, and you can specify the RF channel number that will be used by the Pro:Centric
server as its data channel. The Data Channel value can be set from 0 (disabled) to 135. *
Use the arrow keys on the Installer Remote to select the Data Channel data entry eld and
press OK. You can then use the number keys on the Installer Remote to direct enter the
Data Channel, or you can use the arrow keys to select the appropriate number(s) from the
pop-up virtual keyboard displayed at the bottom of the screen. When you are done, select
Enter from the virtual keyboard, and then press OK on the Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu (Installer Menu item 119)
or in the EZ-Manager Wizard, the specied channel will appear in the Data Channel data entry
eld. If you change the Data Channel in this menu, Installer Menu item 119 will now show the
value you entered here.
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
(Continued on next page)
Network
Pro:Centric
Media Share
Pre-loaded
Apps
PRO:CENTRIC
Mode
Configuration Only
Media Type
RF
Data Channel AUTO
Update Event OFF
^
^