Installation Manual

67
206-4298
IP Environment Setup (Cont.)
(Continued from previous page)
IP Conguration
Enter the Pro:Centric server IP address and port number in the IP Address and Port Number
elds, respectively. The IP address must match the IPv4 multicast address and the port number
must match the port number that is set in the Pro:Centric server.
For each data entry eld: Use the arrow keys to select the eld and press OK. Then, you can
either use the number keys on the Installer Remote to direct enter data values, or you can use
the arrow keys to select the appropriate number(s)/alphanumeric character(s) from the pop-up
virtual keyboard displayed at the bottom of the screen. When you are done, select Enter from
the virtual keyboard, and then press OK on the Installer Remote.
Note: If the server IP address and port number have already been set in the EZ-Manager
Wizard, the specied data will be reected in the elds displayed.
Note: Setting the Media Type to “IP” automatically sets item 119 DATA CHANNEL in the
Installer Menu to 253. You cannot alter this setting unless you revert Media Type to “RF.” Also,
it is not possible to direct enter “253” in the Installer Menu.
4. Select/highlight the Mode eld and press OK on the Installer Remote to display the drop-down
list of options. Then, use the Up/Down arrow keys to select the appropriate Pro:Centric Application
Mode setting—Conguration Only, FLASH, GEM, or HTML. If the Pro:Centric Application Mode
is set to “Conguration Only,” Pro:Centric application data will not be downloaded.
Note: If the mode has already been set in the Installer Menu (item 098 PRO:CENTRIC) or in the
EZ-Manager Wizard, the specied mode will be reected in this eld. If you change the mode in
this menu, Installer Menu item 098 will now reect the value you selected here.
5. Select/specify the appropriate Update Event setting(s), as required. Based on Update Time
settings, the Wake For Update feature wakes the TV once daily to check for, and if applicable,
download updates from the Pro:Centric server. See Installer Menu item 121 UPDATE TIME HR
description on page 46 for additional information on Wake For Update functionality.
• To toggle between ON and OFF in this menu, select/highlight the Update Event eld and
press OK on the Installer Remote. When Update Event is set to “ON,” an Update Time eld is
displayed on the screen.
• If Update Event is ON, set the Update Time as required. Use the arrow keys on the Installer
Remote to select/highlight the Update Time eld, and then press OK. Hour, Minute, and
Meridiem elds will be displayed. Select each eld in turn and specify the appropriate Wake
For Update time, as desired. Note that the Update Time set in this menu is based on a 12-hour
clock. Ensure the meridiem (AM/PM) specication is set accordingly.
6. Once all elds are completed as required, use the arrow keys on the Installer Remote to return to
the IP Environment Menu, as necessary, or press to exit the IP Environment Menu.