Owner's Manual
Table Of Contents
- Preparation
- External equipment setup
- Antenna Connection
- Connecting with a Component cable
- Connecting with an HDMI cable
- Connecting with an HDMI to DVI cable
- Connecting with a Euro Scart cable
- Usb setup
- Connecting with a RF Cable
- Connecting with a RCA cable
- Connecting with a D-sub 15 pin cable
- Insertion of CI Module
- Headphone Setup
- Digital audio out Setup
- External Equipment WIreless Connection
- Supported Display Resolution
- Screen Setup for PC mode
- Watching TV / Programme control
- Turning on the TV
- Initializing Setup
- Programme Selection
- Volume Adjustment
- Quick Menu
- On Screen Menus Selection and adjustment
- Auto programme tuning
- Cable DTV setting
- Manual programme Tuning
- Programme Edit
- CI [Common Interface] Information
- Software Update
- Picture/Sound test
- Diagnostics
- Product/service information
- Simple Manual
- Selecting the Programme List
- Input List
- Input Label
- Data Service
- SIMPLINK
- AV Mode
- Initializing(Reset to original factory settings)
- To use a USB device
- EPG(Electronic programme guide)(in digital mode)
- Picture Control
- Sound & Language control
- Auto Volume Leveler
- Clear Voice II
- Preset Sound Settings-Sound Mode
- Sound Setting Adjustment -User Mode
- Infinite Sound
- Balance
- TV Speakers On/ Off Setup
- DTV Audio Setting (in digital mode only)
- Selecting Digital Audio out
- Audio Reset
- Audio Description (In digital mode only)
- I/II
- On-Screen Menu Language / Country Selection
- Language Selection
- Time Setting
- Parental Control / Ratings
- Teletext
- Digital Teletext
- Appendix
A-15
PREPARATION
FRONT PANEL CONTROLS
■ Image shown may differ from your TV.
NOTE
►TV can be placed in standby mode in order to reduce the power consumption. And TV should be
switched off using the power switch on the TV if it will not be watched for some time, as this will
reduce energy consumption.
►The energy consumed during use can be significantly reduced if the level of brightness of the
picture is reduced, and this will reduce the overall running cost.
CAUTION
►Do not step on the glass stand or subject it to any impact. It may break, causing possible injury
from fragments of glass, or the TV may fall.
►Do not drag the TV. The floor or the product may be damaged.
PROGRAMME
VOLUME
OK
MENU
INPUT
POWER
Remote Control Sensor
Power/Standby Indicator
• Illuminates red in standby mode.
• Illuminates blue when the TV is switched on.
SPEAKER
Only 32/37/42/47LD45
**