Owner's Manual
Table Of Contents
- ACCESSORIES
- PREPARATION
- EXTERNAL EQUIPMENT SETUP
- WATCHING TV / PROGRAMME CONTROL
- Remote Control Key Functions
- Turning on the TV
- Programme Selection
- Volume Adjustment
- Quick Menu
- On Screen Menus Selection and Adjustment
- Freesat Programme Tuning (In Freesat Input -  )
- Non-Freesat Programme Tuning (In Freesat Input -  )
- Auto Programme Tuning (In Antenna Input -  )
- Manual Programme Tuning (In Digital Antenna Mode -  DTV)
- Manual Programme Tuning (In Analogue Antenna Mode -  TV)
- Programme Edit (In Non-Freesat, Digital Antenna or Analogue Antenna Mode Only)
- Custom Edit (In Freesat Mode Only - Freesat)
- Software Update (In Freesat Mode - Freesat)
- Software Update (In Digital Antenna Mode -  DTV)
- Diagnostics
- CI Information (Only for Digital Antenna Mode -  DTV)
- Network (In Freesat Mode- Freesat) (For Future Use)
- Selecting the Programme List
- Input List
- Input Label
- AV Mode
- Initializing (Reset to original factory settings)
- TO USE A USB DEVICE
- TV GUIDE (EPG; ELECTRONIC PROGRAMME GUIDE)(In Freesat, Non-Freesat or Digital Antenna Mode)
- PICTURE CONTROL
- SOUND & LANGUAGE CONTROL
- TIME SETTING
- PARENTAL CONTROL / RATINGS
- TELETEXT (For Analogue Antenna Mode)
- DIGITAL TELETEXT (For Freesat or Digital Antenna Mode)
- APPENDIX
GB-23
EXTERNAL EQUIPMENT SETUP
NOTE :
Avoid keeping a fixed image on the TV’s screen for
prolonged periods of time. The fixed image may
become permanently imprinted on the screen; use a
screen saver when possible.
There may be interference relating to resolution,
vertical pattern, contrast or brightness in PC mode.
Change the PC mode to another resolution or
change the refresh rate to another rate or adjust
the brightness and contrast on the menu until the
picture is clear. If the refresh rate of the PC graphic
card can not be changed, change the PC graphic
card or consult the manufacturer of the PC graphic
card.
The synchronization input waveform for Horizontal
and Vertical frequencies are separate.
We recommend using 1920x1080, 60Hz for the PC
mode, this should provide the best picture quality.
Connect the signal cable from the monitor output
port of the PC to the RGB IN(PC) port of the TV or
the signal cable from the HDMI output port of the
PC to the HDMI/DVI IN 1(DVI) port on the TV.
►
►
►
►
►
Connect the audio cable from the PC to the AUDIO
IN (RGB/DVI) on the TV. (Audio cables are not
included with the TV).
If using a sound card, adjust PC sound as required.
If the graphic card on the PC does not output
analogue and digital RGB simultaneously, connect
only one of either RGB IN or HDMI/DVI IN 1(DVI) to
display the PC output on the TV.
If the graphic card on the PC does output analogue
and digital RGB simultaneously, switch the TV to
either RGB or HDMI; (the other mode is set to Plug
and Play automatically by the TV.)
DOS mode may not work depending on the video
card if you use a HDMI to DVI cable.
If you use too long an RGB-PC cable, there may be
interference on the screen. We recommend using
under 5m of cable. This provides the best picture
quality.
►
►
►
►
►
►