Installation Manual
Table Of Contents
- INSTALLATION MENU
- PUBLIC DISPLAY SETTINGS
- TV MANAGER
- GENERAL
- KEY CODES
- Customizable Portal
- EXTERNAL CONTROL DEVICE SETUP
- TRANSMISSION / RECEIVING PROTOCOL
HCEC Setup
1 Go to General → HCEC Setup.
(1) HCEC Setup
• When HCEC Setup is set to CEC Mode, You can adjust IR Decoding, Device ID, StandBy menu and
SIMPLINK feature automatically changed to the on state, and the user can not change this status.
(a) IR Decoding
• When CEC Mode is set to HCEC Mode, the TV decodes and changes it into a CEC Message and sends
it to Command via the HDMI CEC Line. The default value is Disable.
(b) Device ID
• Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose between All and
E.
• The default value is All.
(c) Stand By
• Sets the sending and receiving scenario of the operation about [CEC Op standBy(0x0c)
Command(Device Power)].
• The detailed scenario is described on the table below.
Send Receive
Send Only O X
Receive Only X O
All O O
Off X X
(2) HTNG HotelMode
• If the following options are selected because of the HTNG command:
* Power On Default, Start Volume, Maximum Volume, Minimum Volume, then the value for the HTNG
HotelMode changes automatically to Enable and, even if the HotelMode is set to Disable, the above
options are still affected.
• If you change it to Disable, then the values set by the HTNG will be canceled.
25
ENGLISH