Installation Manual

Power On Status
• Decide to select working status of TV Set when turn on main power.
• You can set with PWR, STD, LST.
• PWR always make TV set On status when turn on main power .
• STD make Stand-by status when turn on main power.
• LST make TVSet work like previous power status. As same concept as Power Backup mode; If main power
were turned off in Power On status, TVSet would work in On status. If main power were turned off in Stand-
by status, TVSet would work in Stand-by status.
Volume (0 ≤ Min ≤ Start ≤ Max ≤ 100)
• Decide to apply volume policy of Start Volume, Maximum Volume and Minimum Volume
as On (Work) or Off (Do Not Work).
Start Volume
This entry sets the start volume level when is power on.
• The level is specified as a number between minimum volume to maximum value.
(Min ≤ Start ≤ Max)
• The default setting is Off (disabled).
• When enabled, if the value is lower then the minimum specified in the minimum volume entry,
the minimum volume entry must be used.
• When enabled, if the value is larger then the maximum specified in the maximum volume entry,
the maximum volume value must be used.
• Access to a volume in Timer Power On of User Menu must be fixed to start volume when HTNG
HotelMode (Enable) and Start Volume (Off, 0 ~ 100) were set simultaneously.
Maximum Volume
This entry sets the Maximum Volume level the set.
• The level is specified as a number between Minimum Volume to 100. (Min ≤ Max ≤ 100)
• If the command volume up to higher than maximum volume is received, that should be ignored.
• The default value is 100.
Minimum Volume
This entry sets the Minimum Volume level the set will produce.
• The level is specified as a number between 0 to Maximum Volume. (0 ≤ Min ≤ Max)
• If the command volume down to lower than minimum volume is received, that should be
ignored.
• The default value is 0.
5
ENGLISH