LED TV LU34* LU54* 12 14 16 20 AAA X2 (M4 X L16) : Depending on model / www.lg.
1 2 3 4
ANTENNA/ CABLE IN HDMI IN USB IN H/P OUT H/P OUT OPTICAL DIGITAL AUDIO OUT
PCMCIA CARD SLOT OPTICAL DIGITAL AUDIO OUT CLOCK COMPONENT IN AV IN
COMPONENT IN VIDEO/Y PB VIDEO AV IN PR L/MONO AUDIO R AUDIO VIDEO/Y PB PR L/MONO AUDIO R VIDEO L/MONO AUDIO R
HDMI-DVI IN RGB IN RGB IN HDMI IN VIDEO/Y PB PR L/MONO AUDIO R AUDIO OUT VIDEO/Y PB DVI OUT PR L/MONO AUDIO R AUDIO OUT RGB OUT
1 2 3 4 1 2 3 4
0 1 2 A E D B G F 32LU340C-TB 32LU540H-TB C A B C D E F 739 472 168 441 84.0 4.90 Power requirement / F G 4.
OWNER’S MANUAL Safety and Reference LED TV* LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference. www.lg.com Copyright © 2018 LG Electronics Inc. All Rights Reserved.
Warning! Safety Instructions ENGLISH CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
•• Batteries -- Store the accessories (battery, etc.) in a safe location out of the reach of children. -- Do not short circuit, disassemble, or allow the batteries to overheat. Do not dispose of batteries in a fire. Batteries should not be exposed to excessive heat. •• Moving -- When moving, make sure the product is turned off, unplugged, and all cables have been removed. It may take 2 or more people to carry larger TVs. Do not press or put stress on the front panel of the TV.
ENGLISH Preparing Separate Purchase •• If the TV is turned on for the first time after it was shipped from the factory, initialization of the TV may take a few minutes. •• Image shown may differ from your TV. •• Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. •• The available menus and options may differ from the input source or product model that you are using. •• New features may be added to this TV in the future.
Mounting on a Table Please note the following advice to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. 1 Lift and tilt the TV into its upright position on a table. • Leave a 10 cm (minimum) space from the wall for proper ventilation. •• It is recommended to move the TV in the box or packing material that the TV originally came in. •• Before moving or lifting the TV, disconnect the power cord and all cables.
Attaching the TV to a Desk The TV should be attached to a desk so it cannot be pulled in a forward/ backward direction, potentially causing injury or damaging the product. ENGLISH A type Using the Kensington security system •• Image shown may differ from your TV. The Kensington security system connector is located at the rear of the TV. For more information of installation and using, refer to the manual provided with the Kensington security system or visit http://www.kensington.com.
Mounting to the Wall 10 cm 10 cm ENGLISH Attach an optional wall mount bracket at the rear of the TV carefully and install the wall mount bracket on a solid wall perpendicular to the floor. When you attach the TV to other building materials, please contact qualified personnel. LG recommends that wall mounting be performed by a qualified professional installer. We recommend the use of LG’s wall mount bracket. LG’s wall mount bracket is easy to move with cables connected.
Connections ENGLISH Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device. Antenna/Cable Connect the TV to a wall antenna socket with an RF cable (75 Ω). •• Use a signal splitter to use more than 2 TVs. •• If the image quality is poor, install a signal amplifier properly to improve the image quality.
External Speakers Method of Volume control Port (Depending on model) •• Cable Spec. VOLUME CONTROL GND / UP / DOWN Control port for Speaker out + UP - ENGLISH Each Up / Down pin is pulled to 3.3 V with CPU GPIO. EXTERNAL SPEAKER OUT CPU detects transition from 3.3 V to GND level for volume control. DOWN GND RIGHT LEFT GND : Depending on model (Depending on model) •• Use only with the 3 Pole 3.5 mm Stereo Jack.
Using Button Network Wired network connection ENGLISH This TV can be connected to a Pro:Centric server via the LAN port. After making the physical connection, the TV needs to be set up for network communication. You can simply operate the TV functions, using the button. Connect the LAN port of the Modem or Router from Pro:Centric server to the LAN port on the TV.
Adjusting the Angle of the TV to suit view Using Remote Control (Depending on model) 20˚ 20˚ ENGLISH Swivel 20 degrees to the left or right and adjust the angle of the TV to suit your view. The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching the and ends to the label inside the compartment, and close the battery cover.
ENGLISH (POWER) Turns the TV on or off. Adjusts the brightness of the screen to reduce energy consumption. Selects an AV mode. Changes the input source. Selects Radio, TV and DTV programme. Number buttons Enters numbers. Accesses the saved programme list. Returns to the previously viewed programme. Adjusts the volume level. Accesses your favourite programme list. Resizes an image. Mutes all sounds. -- Pressing and holding the button accesses the Accessibility menu.
•• Do not mix new batteries with old batteries. This may cause the batteries to overheat and leak. •• Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. •• This apparatus uses batteries. In your community there might be regulations that require you to dispose of these batteries properly due to environmental considerations. Please contact your local authorities for disposal or recycling information.
Abnormal display ENGLISH •• If the product feels cold to the touch, there may be a small “flicker” when it is turned on. This is normal, there is nothing wrong with product. •• This panel is an advanced product that contains millions of pixels. You may see tiny black dots and/or brightly coloured dots (red, blue or green) at a size of 1 ppm on the panel. This does not indicate a malfunction and does not affect the performance and reliability of the product.
Specifications (Depending on country) ENGLISH Broadcasting Specifications Digital TV Television system Programme coverage Analogue TV PAL B/B, PAL B/G, PAL D/K, PAL-I DVB-T/T2 SECAM B/G, SECAM D/K DVB-C NTSC-M VHF, UHF VHF, UHF, CATV Maximum number of storable programmes 2,000 External antenna impedance 75 Ω CI Module (W x H x D) 100.0 mm x 55.0 mm x 5.
HDMI/DVI-DTV supported mode Horizontal Frequency (kHz) Vertical Frequency (Hz) 31.46 59.94 31.50 31.469 60.00 59.94 720 x 576 31.50 31.250 37.50 60.00 50.00 50.00 1280 x 720 45.00 60.00 44.96 28.125 Resolution ENGLISH 640 x 480 720 x 480 1920 x 1080 HDMI/DVI-PC supported Mode •• PC audio is not supported. •• Use HDMI IN 1 for PC mode (Depending on model) Resolution Horizontal Frequency (kHz) Vertical Frequency (Hz) 640 x 350 31.468 70.09 720 x 400 31.469 70.08 640 x 480 31.469 59.
Supported Photo Formats Extension Item .jpeg, .jpg, .jpe SOF0: baseline SOF1: Extend Sequential SOF2: Progressive File type Item Info Bit rate 32 Kbps - 320 Kbps mp3 Sample freq. 16 kHz - 48 kHz Support MPEG-1, MPEG-2, Layer2, Layer3 Minimum: 64 (W) x 64 (H) Photo Size Maximum (Normal Type): 15,360 (W) x 8,640 (H) ACC Maximum (Progressive Type): 1,920 (W) x 1,440 (H) .bmp Photo Size Available File Type Minimum: 64 (W) x 64 (H) Photo Size Free Format Sample freq.
Supported Video Formats •• Maximum: 1920 x 1080 @ 30p (only Motion JPEG 640 x 480 @ 30p) ENGLISH Extension Codec To obtain the source code under GPL, LGPL, MPL, and other open source licenses, that is contained in this product, please visit http://opensource.lge.com. Video MPEG-4 Part2, XViD, H.264/AVC, VC1(WMV3, WVC1), MP43 Audio WMA Standard, WMA9(Pro), MP3, AAC, AC3 Video MPEG-2, MPEG-4 Part2, XViD, H.
Record the model number and serial number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service.
OWNER’S MANUAL RS-232C Please read this manual carefully before operating your set and retain it for future reference. www.lg.
IR CODES •• This feature is not available for all models.
RS-232C Setup Phone jack Type USB IN EXTERNAL CONTROL DEVICE SETUP (PC) (TV) (Depending on model) •• You need to purchase the phone-jack to RS-232C cable required for the(PC) connection between the PC and the TV, which is specified(TV) in the manual. * For other models, connect to the USB port. 1 3 * The(PC) connection interface may differ from your TV.
RS-232C Configurations Command Reference List (Depending on model) 7-Wire Configurations (Standard RS-232C cable) ENGLISH RXD TXD GND DTR DSR RTS CTS PC 2 3 5 4 6 7 8 D-Sub 9 Command1 Command2 TV 3 2 5 6 4 8 7 D-Sub 9 TXD RXD GND DSR DTR CTS RTS 3-Wire Configurations (Not standard) RXD TXD GND DTR DSR RTS CTS PC 2 3 5 4 6 7 8 D-Sub 9 Communication Parameters •• Baud rate: 9,600 bps (UART) •• Data length: 8 bits •• Parity : None •• Stop bit: 1 bit •• Communication code: ASCII code •• Use a crossed
Transmission / Receiving Protocol (Depending on Model) Transmission OK Acknowledgement [Command2][ ][Set ID][ ][OK][Data][x] * The set transmits ACK (acknowledgement) based on this format when receiving normal data. At this time, if the data is data read mode, it indicates present status data. If the data is data write mode, it returns the data of the PC computer.
3 Screen Mute (Command: k d) 6 Contrast (Command: k g) ►To ► select screen mute on/off. ►To ► adjust screen contrast. You can also adjust contrast in the picture settings. Transmission ENGLISH [k][d][ ][Set ID][ ][Data][Cr] Transmission [k][g][ ][Set ID][ ][Data][Cr] Data 00 : Screen mute off (Picture on) / Video mute off Data 01 : Screen mute on (Picture off) Data 10 : Video mute on Data Min : 00 to Max : 64 * Refer to "Real data mapping".
9 Tint (Command: k j) 12 Remote Control Lock Mode (Command: k m) ►To ► adjust the screen tint. You can also adjust tint in the picture settings. ►To ► lock the front panel controls on the monitor and remote control. Transmission Data Red : 00 to Green : 64 * Refer to "Real data mapping". Ack [j][ ][Set ID][ ][OK/NG][Data][x] 10 Sharpness (Command: k k) ►To ► adjust the screen sharpness. You can also adjust sharpness in the picture settings.
15 Energy Saving (Command: j q) 17 Equalizer (Command : j v) ►To ► reduce the power consumption of the TV. You can also adjust Energy Saving in picture settings. ►To ► adjust equalizer.
19 Programme Skip/Add (Command: m b) 22 Input select (Command: x b) (Main Picture Input) ►To ► set skip status for the current Programme. ►To ► select input source for main picture. Transmission Transmission Data 00 : Skip Data 01 : Add Ack [x][b][ ][Set ID][ ][Data][Cr] Data Structure MSB [b][ ][Set ID][ ][OK/NG][Data][x] 0 LSB 0 0 0 0 External Input 20 Key (Command: m c) 0 0 0 Input Number ►To ► send IR remote key code.
* Real data mapping 00 : Step 0 ENGLISH 10 A: Step 10 (Set ID 10) F: 10 : Step 15 (Set ID 15) Step 16 (Set ID 16) 64 : Step 100 6E : Step 110 73 : 74 : Step 115 Step 116 CF : Step 199 FE : FF : Step 254 Step 255
Record the model number and serial number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service.
