Installation Manual

206-4313

Express Script (Cont.)

(Continued from previous page)

3. Once all elds are completed as required, you have two options:

• To proceed with TV conguration via the Express Script, select NEXT and press OK on the

Installer Remote. Continue to “Complete the TV Conguration” on the following page.

• To save the data entered and exit the Express Script, use the arrow keys to select DONE and

then press OK on the Installer Remote. Remember, however, that if you do not complete the

Express Script, pillow speaker functionality will not be enabled unless you set Installer Menu

item 027 HOSPITAL MODE appropriately. See the “Installer Menu” section of this document

for further information.

Complete the TV Conguration

The following procedure describes the remaining steps in the Express Script. You can select the

“BACK” button, where available, to check previous settings, as necessary. Typically, if you do

not modify the default settings, the “NEXT” button is automatically selected when you proceed

forward within the Express Script. Where appropriate, you can simply press OK on the Installer

Remote to proceed to the next step if the default value(s) for the TV parameter(s) in question are

applicable for your installation.

Note: If you choose to exit the Express Script from this point on, any settings made

will not be retained.

1. In the Select the Tuning Band screen, use the Up/Down arrow keys on the Installer Remote to

highlight/select the appropriate tuning band option: Cable Standard (default), Cable HRC, Cable

IRC, or Air. Then, press OK. When you have made your selection, use the arrow keys to select

NEXT, and then press OK.

SELECT THE TUNING BAND

SAVE

BACK

Select the tuning band you would like to use:

Cable Standard

Cable HRC

Cable IRC

Air

2. By default, all Aux inputs are enabled, as shown initially in the Enable/Disable Aux Inputs

screen. To disable an Aux input, use the arrow keys on the Installer Remote to select the desired

input, and then press OK to toggle the status of the Aux input.

(Continued on next page)