Installation Manual

65
206-4313
IP Environment Setup
The IP Environment Menu enables you to set up the network features of the TV. If you intend to
create a Master TV Setup for cloning purposes (see Master TV Setup procedure on pages 47 to
49), all IP Environment settings, with the exception of Wired Network Connection settings, the TV
name (editable in the Media Share Menu), DIAL, and SoftAP settings, may be cloned.
Note: With the exception of Network Setting conguration, the IP Environment settings are editable
(with the Installer Remote) only if the TV is in Pass-through Mode and read-only when the TV is not
in Pass-through Mode.
Accessing the IP Environment Menu
Note: When you enter the IP Environment Menu, the Installer Menu is exited (all current settings
are saved automatically upon exit). If you are also in the process of updating Installer Menu items,
you may wish to set all items as needed before you access the IP Environment Menu. Otherwise,
after exiting the IP Environment Menu, you will need to reaccess the Installer Menu to set additional
items.
1. Use the Installer Remote to access the Installer Menu (see “Accessing the Installer Menu” on page
37 for further information).
2. Navigate to Installer Menu item 119 DATA CHANNEL, and press 2-5-3 + MENU to launch the IP
Environment Menu.
Use the Up/Down arrow keys on the Installer Remote to select the desired menu option and then
press OK. Refer to the following sections for information on each of the IP Environment setup options.
When you have completed your IP Environment conguration as required, press EXIT or on
the Installer Remote to exit the IP Environment Menu.
Network Conguration
This section describes each of the options available in the Network
Menu (see example at right). Refer to the appropriate subsection(s)
on the following pages.
Note: If you intend to use the Wi-Fi Zoning feature with
cloning conguration, you must congure the wireless
network connection as part of the Master TV Setup. See
“Conguring a Wi-Fi Network Connection” on page 67
for further information.
Accessing the Network Menu
With the IP Environment Menu on display, use the arrow keys on the
Installer Remote to select the Network menu option. Then, press
OK.
Note: The TV’s MAC address is displayed at the top of the Network
Menu screen and cannot be modied.
MAC Address
Network Setting
IP Stream Control
Wake On LAN
NETWORK
Network
Pro:Centric
Media Share
Pre-loaded
Apps
C8:08:E9:40:49:F5