Installation Manual

206-4313

IP Environment Setup (Cont.)

(Continued from previous page)

IP Conguration

Note: If the server IP address and port number or domain name have already been set in the

EZ-Manager Wizard or Express Script, the specied data will be reected in the elds displayed.

Note: Setting the Media Type to “IP” automatically sets item 119 DATA CHANNEL in the Installer

Menu to 253. You cannot alter this setting unless you revert Media Type to “RF.” Also, it is not

possible to direct enter “253” in the Installer Menu.

a) The Server Address eld provides the option to specify the domain name of the Pro:Centric

server instead of the server’s IP address. Select/highlight the Server Address eld and press

OK on the Installer Remote. Then, use the Up/Down arrow keys to select either IP Address or

Domain Name from the drop-down list of options for dening the server.

b) Depending on your selection in the previous step, either:

• Enter the Pro:Centric server IP address in the IP Address eld. The IP address must

match the IPv4 multicast address that is set in the Pro:Centric server.

• Enter the Pro:Centric server domain name in the Domain Name eld. Note that in order

for the domain name to be resolved to an IP address, there must be a DNS entry for the

domain name.

For each data entry eld: Use the arrow keys to select the eld and press OK. Then, you

can either use the number keys on the Installer Remote to direct enter data values, or you

can use the arrow keys to select the appropriate number(s)/alphanumeric character(s) from

the pop-up virtual keyboard displayed at the bottom of the screen. When you are done,

select Enter from the virtual keyboard, and then press OK on the Installer Remote.

c) Enter the Pro:Centric server port number in the Port Number eld. The port number must

match the port number that is set in the Pro:Centric server.

4. Select/highlight the Mode eld and press OK on the Installer Remote to display the drop-

down list of options. Then, use the Up/Down arrow keys to select the appropriate Pro:Centric

Application Mode setting—Conguration Only, FLASH, GEM, or HTML. If the Pro:Centric

Application Mode is set to “Conguration Only,” Pro:Centric application data will not be down-

loaded.

Note: If the mode has already been set in the Installer Menu (item 098 PRO:CENTRIC) or in

the EZ-Manager Wizard or Express Script, the specied mode will be reected in this eld.

If you change the mode in this menu, Installer Menu item 098 will now reect the value you

selected here.

5. Select/specify the appropriate Update Event setting(s), as required. Based on Update Time

settings, the Wake For Update feature wakes the TV once daily to check for, and if applicable,

download updates from the Pro:Centric server. See Installer Menu item 121 UPDATE TIME HR

description on page 47 for additional information on Wake For Update functionality.

• Select/highlight the Update Event eld and press OK on the Installer Remote. Then, use

the Up/Down arrow keys to select either Enable or Disable from the drop-down list of options.

When Update Event is set to “Enable,” an Update Time eld is displayed on the screen.

(Continued on next page)