User guide

20
ENG
ENGLISH
INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING
Mounting on a table
1 Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (minimum) space from the
wall for proper ventilation.
2 Connect the power cord to a wall outlet.
CAUTION

Do not place the TV near or on sources
of heat, as this may result in fire or other
damage.
10 cm
10 cm
10 cm
10 cm
Securing the TV to a table
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
To secure the TV to a table, insert and tighten the
supplied screw on the rear of the stand.
Image shown may differ from your TV.
Adjusting the angle of the TV to suit view
(This feature is not available for all models.)
Adjusting the angle of the TV to suit view swivel
20
±
2
degrees to the left or right and adjust the
angle of the TV to suit your view.
CAUTION

When adjusting the angle of the product,
watch out for your fingers.
- Personal injury may occur if hands or
fingers are pinched. If the product is tilted
too much, it may fall, causing damage or
injury.
Using the Kensington security system
(This feature is not available for all models)
The Kensington security system connector is
located at the rear of the TV. For more information
of installation and using,refer to the manual
privided with the Kensington security system or
visit http://www.kensington.com.
Connect the Kensington security system cable
between the TV and a table.
Image shown may differ from your TV.
NOTE:Kensington security system need buy from
local dealer where you purchased your product.
20
o
±2
o
20
o
±2
o