Operation Manual

Programming the Remote control

G The remote control is a multi-brand or universal remote con-

trol. It can be programmed to operate most remote-controllable

devices of other manufacturers.

Note that the remote control may not control all models of

other brands.

Programming a code into a remote mode

1. Test your remote control.

To find out whether your remote control can operate the compo-

nent without programming, turn on the component such as a

VCR and press the corresponding MODE button (VCR) on the

remote control, while pointing at the component. Test the

POWER and PR +/- buttons to see if the component responds

properly. If not, the remote requires programming to operate the

device.

2. Turn on the component to be programmed, then press the corre-

sponding MODE button on the remote control.

3. Press the PSM and PIP PR- buttons simultaneously, the remote

control is ready to be programmed for the code.

4. Enter a code number using the number buttons on the remote.

Programming code numbers for the corresponding component

can be found on the following pages. Again, if the code is correct,

the device will turn off.

5. Press the PIP PR- button to store the code.

6. Test the remote control functions to see if the component

responds properly. If not, repeat from step 2.

MODE

PSM

PIP PR-

POWER