LED TV LV34** AAA X2 (M4 X L16) 32LV34** 32LV34** www.lg.
2LV34** 1 2 3 4
3/49LV34** B 1 2 3 A BB BB AA B B A BB A 4 BB AA AA 5 B B B A A A
ANTENNA/ CABLE IN HDMI IN USB IN H/P OUT Satellite IN
PCMCIA CARD SLOT OPTICAL DIGITAL AUDIO OUT
COMPONENT IN VIDEO/Y PB VIDEO AV IN PR L/MONO AUDIO R AUDIO VIDEO/Y PB PR L/MONO AUDIO R VIDEO L/MONO AUDIO R
HDMI-DVI IN RGB IN RGB IN HDMI IN VIDEO/Y PB PR L/MONO AUDIO R AUDIO OUT VIDEO/Y PB DVI OUT PR L/MONO AUDIO R AUDIO OUT RGB OUT
1 2 3 4
0 1 A 2 E D B G1 G2 F C A 32LV340C-ZB B C D E F 4.9 F G1 G2 739 472 168 441 84 4.85 43LV340C-ZB 974 625 220 571 79.4 9.3 9.2 49LV340C-ZB 1107 701 235 645 79.4 11.42 11.
OWNER’S MANUAL Safety and Reference LED TV* * LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference. www.lg.
Warning! Safety instructions ENGLISH CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
• Make sure the power cord is connected securely to the power plug on the TV. • Install the product where no radio wave occurs. • There should be enough distance between an outside antenna and power lines to keep the former from touching the latter even when the antenna falls. This may cause an electric shock. • Do not install the product on places such as unstable shelves or inclined surfaces. Also avoid places where there is vibration or where the product cannot be fully supported.
ENGLISH • Please follow the installation instructions below to prevent the product from overheating. -- The distance between the product and the wall should be more than 10 cm. -- Do not install the product in a place with no ventilation (e.g., on a bookshelf or in a cupboard). -- Do not install the product on a carpet or cushion. -- Make sure the air vent is not blocked by a tablecloth or curtain. This may result in fire.
1. Connect to TV. • Do not use any unapproved items to ensure the safety and product life span. • Any damage or injuries caused by using unapproved items are not covered by the warranty. • Some models have a thin film attached on to the screen and this must not be removed. • When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. • Make sure that the screws are fastened completely.
ENGLISH Lifting and moving the TV Using the button Please note the following advice to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. (Depending on model) • It is recommended to move the TV in the box or packing material that the TV originally came in. • Before moving or lifting the TV, disconnect the power cord and all cables. • When holding the TV, the screen should face away from you to avoid damage.
Mounting on a table Basic functions Power On (Press) 1 Lift and tilt the TV into its upright position on a table. • Leave a 10 cm (minimum) space from the wall for proper ventilation. ENGLISH Power Off1 (Press and hold) Volume Control 10 cm Programmes Control 10 cm 10 cm 10 cm Power On (Press) Power Off (Press and Hold) Menu Control (Press2) Menu Selection (Press and Hold3) 1 If the Menu button is on the screen, pressing and holding the button will let you exit the Menu.
Attaching the TV to a desk Using the kensington security system (This feature is not available for all models.) ENGLISH The TV should be attached to a desk so it cannot be pulled in a forward/ backward direction, potentially causing injury or damaging the product. A type) (This feature is not available for all models.) • Image shown may differ from your TV. The Kensington security system connector is located at the rear of the TV.
Adjusting the angle of the TV to suit view Make sure to use screws and wall mount bracket that meet the VESA standard. Standard dimensions for the wall mount kits are described in the following table. (This feature is not available for all models.) Separate purchase(Wall Mounting Bracket) 20˚ 20˚ • When adjusting the angle of the product, watch out for your fingers. -- Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury.
ENGLISH How to use Dual Lock™ Connections (notifications) (Only when the item of the following form is provided) Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device. (This feature is not available for all models.) Fix the set-top box to the TV and use it when you want to.
CI module connection (Depending on model) • Use only with the 3 Pole 3.5 mm Stereo Jack. • Do not connect your headphones or earphones to the port for connecting an external speaker. View the encrypted (pay) services in digital TV mode. Method of Volume control port (Depending on model) • Cable Spec. Each Up / Down pin is pulled to 3.3 V with CPU GPIO. Speaker Output Setup (Depending on model) ENGLISH • Check if the CI module is inserted into the PCMCIA card slot in the right direction.
Remote control Network setup Wired network connection ENGLISH (Depending on model) This TV can be connected to a Pro:Centric server via the LAN port. After making the physical connection, the TV needs to be set up for network communication. Connect the LAN port of the Modem or Router from Pro:Centric server to the LAN port on the TV. (MHEG & SERVICE) (Some buttons and services may not be provided depending on models or regions.
(Depending on model) ENGLISH (POWER) Turns the TV on or off. Selects Radio, TV and DTV programme. Recalls your preferred subtitle in digital mode. Audio descriptions function will be enabled. Resizes an image. (INPUT) Changes the input source. Number buttons Enters numbers. Accesses the saved programme list. Returns to the previously viewed programme. Adjusts the volume level. Accesses your favourite programme list. Shows programme guide. (MUTE) Mutes all sounds. Scrolls through the saved programmes.
ENGLISH (POWER) Turns the TV on or off. Adjusts the brightness of the screen to reduce energy consumption. Selects an AV mode. Changes the input source. Selects Radio, TV and DTV programme. Number buttons Enters numbers. Accesses the saved programme list. Returns to the previously viewed programme. Adjusts the volume level. Accesses your favourite programme list. Resizes an image. Mutes all sounds. Scrolls through the saved programmes. PAGE Moves to the previous or next screen. Shows programme guide.
Troubleshooting Cannot control the TV with the remote control. • Check the remote control sensor on the product and try again. • Check if there is any obstacle between the product and the remote control. • Check if the batteries are still working and properly installed ( to , to ). No image display and no sound is produced. • Check if the product is turned on. • Check if the power cord is connected to a wall outlet. • Check if there is a problem in the wall outlet by connecting other products.
Specifications ENGLISH CI Module Size (W x H x D) Environment condition 100.0 mm x 55.0 mm x 5.
HDMI/DVI-DTV supported mode Vertical Frequency (Hz) 640 x 480 31.46 31.50 59.94 60.00 720 x 480 31.469 31.50 59.94 60.00 720 x 576 31.250 50.00 1280 x 720 37.50 45.00 44.96 50.00 60.00 59.94 1920 x 1080 28.125 33.75 33.72 56.250 67.50 67.432 27.00 26.973 33.75 33.716 50.00 60.00 59.94 50.00 60.00 59.94 24.00 23.976 30.00 29.
Supported video formats ENGLISH • Maximum: 1920 x 1080 @ 30p (only Motion JPEG 640 x 480 @ 30p) • .asf, .wmv [Video] MPEG-4 Part2, XViD, H.264/AVC, VC1(WMV3, WVC1), MP43 [Audio] WMA Standard, WMA9(Pro), MP3, AAC, AC3 • .divx, .avi [Video] MPEG-2, MPEG-4 Part2, DivX3.11, DivX4, DivX5, DivX6, XViD, H.264/AVC [Audio] HE-AAC, LPCM, ADPCM, MPEG- 1 Layer I, MPEG-1 Layer II, Dolby Digital, MPEG-1 Layer III (MP3) • .ts, .trp, .tp, .mts, .m2ts [Video] H.264/AVC, MPEG-2, H.
Supported photo formats ENGLISH • Category : 2D (jpeg, jpg, jpe) [Available file type] SOF0 : Baseline, SOF1 : Extend Sequential, SOF2 : Progressive [Photo size] Minimum : 64 x 64, Maximum (Normal Type) : 15360 (W) x 8640 (H), Maximum (Progressive Type) : 1920 (W) x 1440 (H) • Category : BMP [Photo size] Minimum : 64 x 64, Maximum : 9600 x 6400 • Category : PNG [Available file type] Interlace, Non-Interlace [Photo size] Minimum : 64 x 64, Maximum (Interlace) : 1200 x 800, Maximum (Non-Interlace) : 9600 x
Record the model number and serial number of the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service.
IR CODES • This feature is not available for all models.
EXTERNAL CONTROL DEVICE SETUP Type of Connector : D-Sub 9-Pin Male 1 5 ENGLISH RS-232C Setup • Image shown may differ from your TV. Connect the RS-232C (serial port) input jack to an external control device (such as a computer or an A/V control system) to control the product’s functions externally. Connect the serial port of the control device to the RS-232C jack on the product back panel. • RS-232C connection cables are not supplied with the product.
RS-232C Configurations Command Reference List (Depending on model) 7-Wire Configurations (Standard RS-232C cable) RXD TXD GND DTR DSR RTS CTS PC 2 3 5 4 6 7 8 TV 3 2 5 6 4 8 7 D-Sub 9 D-Sub 9 TXD RXD GND DSR DTR CTS RTS 3-Wire Configurations (Not standard) RXD TXD GND DTR DSR RTS CTS PC 2 3 5 4 6 7 8 TV 3 2 5 6 4 7 8 D-Sub 9 D-Sub 9 Communication Parameters • • • • • • Baud rate: 9600 bps (UART) Data length: 8 bits Parity : None Stop bit: 1 bit Communication
Transmission / Receiving Protocol (Depending on Model) ENGLISH Transmission [Command1][Command2][ ][Set ID][ ][Data][Cr] [Command 1] : First command to control the TV. (j, k, m or x) [Command 2] : Second command to control the TV. [Set ID] : You can adjust the set ID to choose desired monitor ID number in option menu. Adjustment range is 1 to 99. When selecting Set ID ‘0’, every connected set is controlled.
03. Screen Mute (Command: k d) ►To ► select screen mute on/off. Data 00 : Screen mute off (Picture on) Video mute off 01 : Screen mute on (Picture off) 10 : Video mute on Ack [d][ ][Set ID][ ][OK/NG][Data][x] * In case of video mute on only, TV will display On Screen Display(OSD). But, in case of Screen mute on, TV will not display OSD. 04. Volume Mute (Command: k e) ►To ► control volume mute on/off. You can also adjust mute using the MUTE button on remote control.
08. Colour (Command: k i) ►To ► adjust the screen Colour. You can also adjust colour in the PICTURE menu. ENGLISH Transmission [k][i][ ][Set ID][ ][Data][Cr] 12. Remote Control Lock Mode (Command: k m) ►To ► lock the front panel controls on the monitor and remote control. Transmission [k][m][ ][Set ID][ ][Data][Cr] Data 00 : Lock off Data Min : 00 to Max : 64 * Refer to Real data mapping 01 : Lock on Ack [m][ ][Set ID][ ][OK/NG][Data][x] Ack [i][ ][Set ID][ ][OK/NG][Data][x] 09.
15. Energy Saving (Command: j q) ►To ► reduce the power consumption of the TV. You can also adjust Energy Saving in PICTURE menu.
Channel data range Min : 00 Max : 270F (0 to 9999) ENGLISH Ack [a][ ][Set ID][ ][OK/NG][Data][x] 19. Programme Add/Skip (Command: m b) ►To ► set skip status for the current Programme. Data Structure MSB LSB 0 01 : Add 20. Key (Command: m c) ►To ► send IR remote key code. Transmission [m][c][ ][Set ID][ ][Data][Cr] 0 0 IR CODES 21.
* Real data mapping 00 : Step 0 Step 10 (Set ID 10) F: 10 : Step 15 (Set ID 15) Step 16 (Set ID 16) 64 : Step 100 6E : Step 110 73 : 74 : Step 115 Step 116 CF : Step 199 FE : FF : Step 254 Step 255 ENGLISH A: 9
