Installation Manual

50
206-4317 Draft A.2
(Continued from previous page)
IP Confi guration
In the Server IP and Port Number fi elds, either key in or use the Left/Right arrow keys to select
the appropriate values for the Pro:Centric server IP address and port number. The IP address
must match the IPv4 multicast address and the port number must match the port number that
is set in the Pro:Centric server.
Note: If the server IP address and port number have already been set in the EZ-Manager
Wizard, the specifi ed data will be refl ected in the fi elds displayed.
Note: Setting the Media Type to “IP” automatically sets the Data Channel fi eld to “253.” You
cannot alter this setting unless you revert Media Type to “RF.” Also, it is not possible to direct
enter “253” in the Data Channel fi eld.
4. Select/highlight the Mode fi eld, and use the Left/Right arrow keys to select the appropriate
Pro:Centric Application Mode setting—Confi guration Only, FLASH, or GEM. If the Pro:Centric
Mode is set to “Confi guration Only,” Pro:Centric application data will not be downloaded.
Note: If the mode has already been set in the Installer Menu (item 098 PRO:CENTRIC) or in
the EZ-Manager Wizard, the specifi ed mode will be refl ected in this fi eld. If you change the
mode in this menu, Installer Menu item 098 will now refl ect the value you selected here.
5. In the Update Event field, use the Left/Right arrow keys to select On or Off, as required. Based
on the Update Time settings, the Wake For Update feature wakes the TV once daily to check
for, and if applicable, download updates from the Pro:Centric server. See Installer Menu item
121 UPDATE TIME HR description on page 32 for additional information on Wake For Update
functionality.
If you set Update Event to “On,” specify the appropriate Wake For Update time in the Update
Time fi elds, as desired. Note that the Update Time set in this menu is based on a 12-hour clock.
Ensure the AM/PM specifi cation is set accordingly.
6. Once all fi elds are completed as required, either select Close and then press OK on the Installer
Remote or press to return to the IP Environment Menu.
IP Environment Setup (Cont.)