Installation Manual

ENGLISH
14
HCEC Setup
(Depending on model)
CEC Mode
(Depending on model)
• You will have 2 modes to choose [Default], [HCEC].
• If [Default] is selected, you can use SIMPLINK which is provided in LG TV. Also you can enable and disable SIMPLINK through SIMPLINK MENU.
• If [HCEC] is selected, you can use TVLink-HCEC Protocol. (For more detailed information, please refer to TVLink-HCEC Protocol document)
IR Decoding
• When ‘IR Decoding’ is set to ‘Enable’, the TV decodes and changes it into a CEC Message and sends it to Command via the HDMI CEC Line. The
default value is Disable.
Device ID
• Sets the ID of a device(Logical Address) connected to the CEC Line. You can choose ‘All’ and from ‘0 x 01’ to ‘0 x 0E’(All, 0 x 01 ~ 0 x 0e).
• The default value is ‘All’.
StandBy
• Set the sending and receiving scenario of OpStandBy(0 x 0c) command.
• Ths detailed scenario is described on the table below.
Send Receive
Send Only O X
Receive Only X O
All O O
O X X
HTNG Public Display Mode
• If you use following functions via TVLink-HCEC, HTNG Public Display Mode will be set as “Yes” automatically.
-
Power On Default, Start Volume, Maximum Volume, Minimum Volume, or Start Volume.
• Even if ‘Public Display Settings Operation’ is set as No, above settings are still eective.