Owner’s Manual

ENGLISH
14
ASSEMBLING AND PREPARING
Mounting on a Table
1
Lift and tilt the TV into its upright position on a table.
- Leave a 10 cm (4 inches) (minimum) space from
the wall for proper ventilation.
10 cm
10 cm
10 cm
10 cm
(4 inches)
2
Connect the power cord to a wall outlet.

Do not place the TV near or on sources of heat, as
this may result in fire or other damage.
CAUTION
Using the Kensington security system (optional)
The Kensington security system connector is located at
the rear of the TV.
For more information of installation and using, refer
to the manual provided with the Kensington security
system or visit http://www.kensington.com.
Connect the Kensington security system cable between
the TV and a table.

The Kensington security system is optional. You
can obtain additional accessories from your local
dealer.
NOTE
Securing the TV to a table
Attach the TV to a table to prevent from tilting forward,
damage, and potential injury.
Mount the TV on a table, and then insert and tighten the
supplied screw on the rear of the stand.

To prevent TV from falling over, the TV should be
securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the TV
may cause injury.
WARNING
Adjusting the angle of the TV to suit view
(For 32LN541C, 32LN549E, 32LP560M)
Swivel 15 degrees to the left or right and adjust the angle
of the TV to suit your view.
15˚15˚
(For 39/42/47/55LN541C, 39/42/47/55LN549E, 42LP560M)
Swivel 90 degrees to the left or right and adjust the angle
of the TV to suit your view.
90˚90˚

When adjusting the angle of the TV, watch out for
your fingers.
- Personal injury may occur if hands or fingers are
pinched. If the product is tilted too much, it may
fall, causing damage or injury.
CAUTION