Installation Manual

206-4279

• Avoid using special characters, such as ?, &, @, etc., in the Clone/Conguration (.tlx) lename.

• If the EZ-Manager Wizard appears on the screen when you turn ON the Target TV, you can

use the wizard’s “USB Conguration” option to access the TV Manager and complete the import

procedure (see “TV Conguration Options” and/or “USB Conguration” on pages 14 and 20,

respectively, as necessary).

• You may also use the Ez Download utility to import the Clone/Conguration (.tlx) le. See “Ez

Download Utility” on pages 22 to 25 for further information.

• If the Target TV is currently in Pass-through Mode and you intend to use the TV’s Zoning

feature(s)—i.e., the Clone/Conguration (.tlx) le you are importing contains an FTG Channel

Map and/or FTG prole(s) with TV Zone and/or Wi-Fi Zone assignments—make sure to assign

the appropriate TV Zone # and/or Wi-Fi Zone # in the TV when directed to do so in the procedure

below. See Reference section, “Using the TV’s Zoning Features,” for further information.

• If you would like the Target TV(s) to remain in Pass-through Mode after the Clone/Conguration

(.tlx) le is imported, ensure the “.tlx” le does not contain an FTG Channel Map; otherwise, the

import procedure will result in the Target TV(s) being congured for FTG Mode via CPU.

• If a Clone (.tlx) le (exported Master TV Setup) contains an FTG Channel Map, the physical RF

channels in the FTG Channel Map have been assigned logical channel numbers (see “Exporting

a Clone File” above). When you import the Clone le with the FTG Channel Map on the Target

TV(s), you will have the option to select either logical or physical channel tuning. Even if you

select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will

remain in logical order.

• If an FTG Conguration (.tlx) le (created in the FTG File Manager) contains an FTG Channel

Map, each logical channel number in the FTG Channel Map has been assigned a physical RF

channel, an IP channel, or an Aux input (the latter designated by 130-0 through 137-0—see also

Reference section, “TV Aux Input Conguration”).

Note: If the FTG Channel Map includes RF channels and Aux inputs only, when you import

the FTG Conguration le on the Target TV(s), you will have the option to select either logical or

physical channel tuning. If you select physical channel tuning, the physical RF channels and

Aux inputs in the FTG Channel Map will remain in logical order. Physical channel tuning is not

available when the FTG Channel Map includes IP channels.

• If the Target TV EBL is already in FTG Mode, you cannot use this procedure to make changes

to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV

connection as described in Reference section, “FTG Mode via EBL (Local Conguration),” or an

FMA head end device to recongure the EBL.

• If the preceding condition applies, but you wish to switch the TV to FTG Mode via CPU, see

Reference section, “Restoring Factory Defaults on the TV(s),” for further information before

proceeding.

• If the Clone/Conguration (.tlx) le was edited/created in the FTG File Manager, it may contain

multiple zoned FTG Installer Menu proles for different TV models. Make sure it includes the

appropriate Installer Menu prole(s) for the Target TV(s) before performing the procedure below.

Caution: Do not unplug the TV power cord or remove the USB memory device while

importing is in progress, as doing so may cause the TV to malfunction or harm the

USB device, respectively.

Cloning Procedures (Cont.)