Owner’s Manual

ENGLISH
9
Intelligent Auto
• You can set this feature to On (enabled) or Off (disabled).
• If you change the screen resolution after setting this feature to ‘Yes’, the display is automatically adjusted to the new
resolution.
(This feature may not be available with some models.)
Master/Slave Mode
• This feature allows you to sync monitors connected via RS-232C.
• When various monitors are connected via RS-232C, the forefront monitor becomes the Master.
• Once the Master is selected, the rest become Slaves.
• If you want to change the Master monitor, you must change it in Master/Slave Mode.
(This feature may not be available with some models.)
NOTE
• The Master/Slave Mode menu is only enabled when Picture ID is set to Off.
• When entering or editing Master/Slave Mode, the menu cursors on the Slave monitors may not be moved.
Time Sync Clock
• This feature syncs the Slave monitors’ clocks to the Master monitor’s at a specified time via RS-232C.
• On the Master monitor, you can set the sync time as well as setting Time Sync Clock to Off .
• You can select a sync time between 0:00 - 23:00.
• While Time Sync Clock is performed, RS-232C control of other commands may not work.
(This feature may not be available with some models.)
NOTE
• To synchronize Time Sync Clock, be sure to set each slave monitor’s clock so that they are at least one minute later
than the master monitor’s clock.
• If the Clock setting is Auto, the setting is changed to Manual when Time Sync Clock runs.