Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
27
Timer
• Immediately: Performs the ISM function immediately after the ISM Method menu window disappears. The Period/
Time option is disabled.
a) Inversion: Inverts the screen every 30 minutes.
b) Orbiter: The image moves 3 pixels every 2 minutes in a certain order.
c) User Image: Displays the image on repeat until you press the EXIT button on your remote control.
• Repeat: Performs the ISM function for a specified amount of time in each period. (Period and Time are only enabled
when Repeat is selected.)
a) Inversion: Inverts the screen for a specified amount of time and then restores the screen to its original settings.
The period will be calculated again after the screen is restored.
b) Orbiter: Moves the image 3 pixels at specified time intervals. In Repeat mode, the Orbiter function is terminated
only when a movie is output or when there is a button input from the remote control. After the
termination of the Orbiter function, the period will be calculated again.
c) User Image: You can terminate User Image by pressing the EXIT button on your remote control before a specified
time passes. After termination of the User Image function, the period will be calculated again.
Period
• You can set the period between 1 and 24 hours.
• When there is a button input from your remote control, this function is terminated and the period is calculated again.
Time
• You can select from among 1 - 10 mins / 20 mins / 30 mins / 60 mins / 90 mins / 120 mins / 180 mins / 240 mins
• The ISM function is performed for a specified period.
NOTE
Still Image Detecting and ISM Method
• If you set Still Image Detecting to Yes, the ISM function starts when the amount of time the image has been still
reaches a specified period. When a movie is output, the function is terminated and the period is recalculated.
• If you set Still Image Detecting to No, the ISM function starts when the amount of time no button input from the
remote control is detected reaches a specified period.