Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
12
ENGLISH
Attaching and Removing the LG Logo Bracket
- For certain models only.
- The image may be different according to the model.
Removing the LG Logo
1 Lay a clean cloth on the floor, and then put
the monitor on it with the screen face down.
Remove the two screws that secure the LG
Logo Bracket to the bottom of the rear side of
the monitor using a screwdriver.
2 After removing the screws, remove the LG
Logo. When re-attaching the LG Logo, follow
the process in reverse order.
Attaching the LG Logo on the right side
1 Lay a clean cloth on the floor, and then put
the monitor on it with the screen face down.
Remove the two screws that secure the LG
Logo Bracket to the bottom of the rear side of
the monitor using a screwdriver.
2 After removing the screws, remove the LG
Logo. Attach the LG Logo Bracket with the two
screws, aligning it with the holes at the right
side.
LG Logo Bracket