Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
13
ENGLISH
Installing on a Wall
For proper ventilation, allow a clearance of 10
cm on each side and from the wall. Detailed
installation instructions are available from your
dealer, see the optional Tilt Wall Mounting Bracket
Installation and Setup Guide.
To install your monitor on a wall, attach a wall
mounting bracket (optional part) to the back of the
monitor.
Make sure that the wall mounting bracket is
securely fixed to the monitor and to the wall.
1 Use only screws and wall mounting brackets
that conform to VESA standards.
2 Screws which are longer than standard length
may damage the inside of the monitor.
3 A non-VESA standard screw may damage
the product and cause the monitor to fall. LG
Electronics is not liable for any accidents related
to the use of non-standard screws.
4 Please use VESA standard as below.
• 785 mm and above
* Fixing screws: Diameter 6.0 mm x Pitch
1.0 mm x Length 12 mm
10 cm
10 cm
10 cm
10 cm
10 cm
• Disconnect the power cord before moving or installing the monitor to avoid risk of electric shock.
• If you install the monitor on a ceiling or slanted wall, it may fall and result in injury. Use an authorized LG wall
mount and contact your local dealer or qualified personnel to assist with the installation.
• Do not over tighten the screws as this may damage the monitor and void your warranty.
• Use only screws and wall mounting brackets that meet the VESA standard. Any damage or injuries caused by
misuse or use of improper accessories are not covered by the warranty.
CAUTION
• The wall mount kit includes the installation guide and all necessary parts.
• The wall mounting bracket is optional. You can obtain additional accessories from your local dealer.
• The length of screws required may differ depending on the wall mount. Be sure to use the correct length.
• For more information, please refer to the guide provided with the wall mount.
NOTE
785 mm