Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
4
CAUTION
• If a fixed image displays on the screen for a long period of time, it will be imprinted and become a permanent
disfigurement on the screen. This is image burn or burn-in and not covered by the warranty.
• If you don’t use your monitor, turn the power off or set a screen saver program from the PC or the system to prevent
image retention.
• If the aspect ratio is set to 4:3 for a long period of time, image burn may occur on the letterboxed area of the screen.
• 16:9 : This selection will allow you to adjust the picture horizontally, in linear proportion, to fill the entire screen
(useful for viewing 4:3 formatted DVDs).
• Just Scan : This Selection will allow you view the picture of best quality without loss of original picture in high
resolution image. Note: If there is noise in original Picture, You can see the noise at the edge.
• Set By Program : Depending on the input signal, screen aspect ratio changes to 4:3 or 16:9.
• 4:3 : This selection will allow you to view a picture with an original 4:3 aspect ratio, black bars will appear on both the
left and right of the screen.
• Zoom : This selection will allow you to view the picture without any alteration, while filling the entire screen. However,
the top and bottom of the picture will be cropped.
• Cinema Zoom1 : Choose Cinema Zoom when you want to enlarge the picture in correct proportion. Note: When
enlarging or reducing the picture, the image may become distorted.










