Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
25
Setting Description
Screen
(In RGB Mode
Only)
Customizes the PC display options in RGB mode.
Option
Resolution Selects a proper resolution.
Auto Configure Sets to adjust the screen position, clock, and phase automatically.
The displayed image may be unstable for a few seconds while the
configuration is in progress.
Position/Size/
Phase
Adjusts the options when the picture is not clear, especially when
characters are shaky, after the auto configuration.
Reset Restores the options to the default setting.
Basic image options
Setting Description
Backlight
Adjusts the brightness of the screen by controlling the LCD backlight. If you decrease the
brightness level, the screen becomes darker and the power consumption will be reduced without
any video signal loss.
Contrast Increases or decreases the gradient of the video signal. You may use Contrast when the bright
part of the picture is saturated.
Brightness Adjusts the base level of the signal in the picture. You may use Brightness when the dark part of
the picture is saturated.
Sharpness
Adjusts the level of crispness in the edges between the light and dark areas of the picture. The
lower the level, the softer the image.
Color
Adjusts intensity of all colors.
Tint
Adjusts the balance between red and green levels.
Color Temp.
Set to warm to enhance hotter Colors such as red, or set to cool to make picture bluish.
Advanced
Control/
Expert Control
You can adjust the picture for each Picture Mode, or adjust the picture settings according to a
specific picture image. First, select a desired Picture Mode.
* This option is unavailable if Picture Mode is set to Vivid.
Picture Option
Sets additional picture option.
Picture Reset
Restores the options to the default setting.
NOTE
• When you select a picture mode, related menus are set automatically.
• When using the Smart Energy Saving function, the screen may look saturated in the white area of a still image.
• If Energy Saving is set to Minimum, Medium, or Maximum, the Smart Energy Saving function is disabled.