Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
51
48. Tile V Position (Command: d f)
To adjust the Tile Vertical position.
* This function is available only when the Natural option
of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][f][ ][Set ID][ ][Data][Cr]
Data 0 to 32: 0 (Bottom) to 50 (Top)
* Bottom/Top values depend on Tile Vertical size.
* It may not be supported depending on the model.
Acknowledgement
[f][ ][Set ID][ ][OK/NG][Data][x]
49. Tile H Size (Command: d g)
To adjust the Tile Horizontal Size.
* Set Tile H Position to 0x32 before setting Tile H Size.
* This function is available only when the Natural option
of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][g][ ][Set ID][ ][Data][Cr]
Data 00 to 32: 0 to 50
* It may not be supported depending on the model.
Acknowledgement
[g][ ][Set ID][ ][OK/NG][Data][x]
50. Tile V Size (Command: d h)
To adjust the Tile Vertical size.
* Set Tile V Position to 0x00 before setting Tile V Size.
* This function is available only when the Natural option
of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][h][ ][Set ID][ ][Data][Cr]
Data 00 to 32: 0 to 50
* It may not be supported depending on the model.
Acknowledgement
[h][ ][Set ID][ ][OK/NG][Data][x]
51. Natural Mode (In Tile Mode) (Command: d j)
To display the image naturally, the part of the image
that would normally be displayed in the gap between
the monitors is omitted.
Transmission
[d][j][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]