Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
10
Sync Mode
• This feature allows you to sync the start times of contents (videos or images that have been distributed by SuperSign
Software) played back on the Master and Slave monitors.
• If you set Sync Mode to Off, the sync feature is disabled.
• A Slave monitor plays contents at the same time as the Master monitor.
• While Sync Mode is performed, RS-232C control of other commands may not work.
(This feature may not be available with some models.)
DPM Wakeup Control
• This feature sets conditions for releasing the DPM status according to the DVI/HDMI’s processing of digital signals.
• Clock: Checks the clock signal of the digital signal and, if the clock signal exists, releases the DPM status.
• Sync: Releases the DPM status when both the clock signal and data of the digital signal are entered.
Still Image Detecting
• This feature detects still images.
• If you set this feature to Yes, you can use the RS-232C command for detecting still images.
PM Mode
• This feature activates some of the monitor’s functions after it enters Off status, allowing the monitor to remain
practically the same as when it is turned on.
• Power Off: All functions remain turned off except some functions (Power, Time, etc.) when the monitor turns off.
(Extended Display Identification Data (EDID) may be sustained depending on the input and model.)
• Sustain Aspect Ratio: Sustains Extended Display Identification Data (EDID) even when the monitor is turned off.
• Screen Off: Only turns off the screen and audio when the monitor enters Auto Off/Automatic Standby/DPM.
Network-based control is possible.
• Screen Off Always: Has the same function as PM Mode’s Screen Off. Entering and releasing the Screen Off status
using a remote control is also possible.