Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- LG Digital Signage Setup menu
- Signage Mode Operation
- Power On Status
- Key Operation
- IR Operation / Local Key Operation
- Limited Mode
- Input Source Change
- Menu Display
- OSD Display
- Power On Default (Input Source, A/V Setting, Aspect Ratio)
- Input Source
- A/V Setting
- Aspect Ratio
- Wake On LAN
- DPM
- Digital Audio Input
- Speaker
- Power On Delay
- Pivot Mode
- OSD Portrait Mode (Off, 90, 270)
- Intelligent Auto
- Master/Slave Mode
- Time Sync Clock
- Sync Mode
- DPM Wakeup Control
- Still Image Detecting
- PM Mode
- Factory Reset
- OPS/PC Power Control
- Interface Selection
- Check Screen
- Factory Reset VS Initial Setting
- Signage Mode Operation
- USB Cloning
- Password Change
- Set ID Setup
- Configuration Setup
- Lock Mode
- External Speaker / Audio out
- Fail Over
- ISM Method
- Easy Brightness Control
- SuperSign Server Setup
- Holiday Schedule
- No Signal Image
- Crestron
- Digital Signage Media Player
- LG Digital Signage Setup menu
ENGLISH
17
Send to DaisyChain
This feature allows you to copy the settings of a monitor to other monitors using RS-232C.
1 Transfer the settings of your current monitor to other linked monitors via RS-232C outputs.
2 The settings of the foremost monitor are copied, while the settings for other monitors in the RS-232C daisy-chain
are not.
3 Select Send to DaisyChain, then select Yes to transfer the data or select No to go back to the previous menu.
4 Repeat this until all monitors that are connected to the current monitor’s RS-232C output port turn off. After the
monitors turn off, turn them on and check if the settings have been copied.
(This feature may not be available with some models.)
All user settings will be Send to Daisy Chain.
Still Continue?
Yes No
Transfer Start !!!!
USB Cloning
Ez Download
Receive from USB
Send to USB
Logo Image Download
Send to Daisy Chain
OK
Previous