Owner’s Manual

2
ENG
ENGLISH
ACCESSING INSTALLATION MENU
Installation Menu
NOTE

Default values may differ by region.
The LG Digital Signage Setup menu
This menu is used after installation to configure the Digital Signage.
LG Digital Signage Setup
USB Cloning
Password Change
Set ID Setup
Configuration Setup
Lock Mode
Fail Over
SuperSign Server Setup
Easy Brightness Control
S/W : xx.xx.xx.xx Micom : x.xx.x
OK
LG Digital Signage Setup
Signage Mode Operation
• Power On Status
• Key Operation
• IR Operation
• Local Key Operation
• Limited Mode
• Input Source Change
• Menu Display
• OSD Display
STD
No
Normal
Normal
No
Yes
Yes
Yes
Yes
LG Digital Signage Setup
• Power On Default
• Input Source
• A/V Setting(Video setting)
• Aspect Ratio
• Wake On LAN
• DPM
• Digital Audio Input
• Speaker
No
Disable
Off
OK
Previous
Installation Menu (V 3.0)
LG Digital Signage Setup
LG Digital Signage Setup
Confirm
• Sync Mode
• Power On Delay
• Pivot mode
• OSD Portrait Mode
• Intelligent Auto
• Factory Reset
On
Off
Off
OK
Previous
No
Off
10min.
Analog
On
OK
Previous
Slave
Off
Signage Mode Operation

Decide to work all functions of
Signage Mode Operation
or not by setting
Signage Mode Operation
as Yes (Work) or No (Do Not Work)

When
Signage Mode Operation
is set to Yes(Work), all functions of Signage Mode apply.

When
Signage Mode Operation
is set to No(Do Not Work), all functions of Signage Mode Do Not apply
and runs on initial value.
(It may not work depending upon the model.)
Power On Status

Select the status of the monitor set when turning on the main power.

You can set with PWR, STD, or LST.

PWR always turns the monitor ON with the main power.

STD turns the monitor on in the STAND-BY mode.

LST turns the monitor to its previous status. If the main power were turned off in POWER ON status, the
monitor would power up in POWER ON. If it were turned off in STAND-BY status, it would power up in
STAND-BY.
(This may not function, depending upon the model.)