Owner’s Manual
Table Of Contents
4
ENG
ENGLISH
ACCESSING INSTALLATION MENU
Power On Default (Input Source, A/V Setting, Aspect Ratio)
With the power turned on, you can set the
Input Source
,
A/V Setting
and
Aspect Ratio
options.
Set to Yes (Work) or No (Do Not Work).
If
Power On Default
is set to No,
Input Source
and
Volume
are deactivated.
When
Power On Default
is set to Yes, it can set by entering the subordinate menu.
(It may not work depending upon the model.)
Input Source
Set whether it is turned on by the set input source or by the last stored input source.
It is turned on by the Last Memory Input if the
Input source
is turned off.
All sources supported by the said model can be set as Input source.
If both the
Input source
and the
ON TIME
are set, the
Input source
takes the priority.
(It may not work depending upon the model.)
A/V Setting(Video Setting)
When your monitor is powered on, you can set certain options for A/V.
If you set this feature to Yes, the A/V values you set before entering the Installation Menu are saved,
and even if you have changed A/V values before powering off, the saved values are restored when you
power on your monitor again.
Saves video values: Picture Mode, DPM Select, Smart Energy Saving, Backlight, Contrast, Brightness,
Sharpness, Color, Tint and Color Temp.
Saves audio values: Sound Mode and Balance.
(It may not work depending upon the model.)
Aspect Ratio
This feature enables you to set the screen size that will be applied to your monitor upon powering on.
Selecting
Disable
sets the screen size of your monitor upon powering on to
Aspect Ratio
.
Selecting
Set By Program
sets the screen size of your monitor upon powering on to
Set By Program
.
Selecting
4:3
sets the screen size of your monitor upon powering on to
4:3
.
Selecting
16:9
sets the screen size of your monitor upon powering on to
16:9
.
(It may not work depending upon the model.)
Wake On LAN
Sets whether to use
Wake On LAN
.
It can be set to On or Off.
On:
Wake On LAN
is enabled, and you can turn on the product remotely via LAN.
Off:
Wake On LAN
is disabled.
(It may not work depending upon the model.)
DPM
Sets whether to use
DPM
(Display Power Management).
It can be set to Off, 5 sec, 10 sec, etc.
Others: If there is no input signal, the product enters into standby mode.
Off:
DPM
is disabled.
(It may not work depending upon the model.)
Digital Audio Input
You can set the audio for each input as
Analog
or
Digital
.
In the case of RGB input, audio is fixed as
Analog
.
In the case of Digital input, you can set the audio as
Analog
or
Digital
.
(It may not work depending upon the model.)