Owner’s Manual

13
ENG
ENGLISH
ACCESSING INSTALLATION MENU
Password Change
You can change the password for security.
Enter a new 4-digit number in
Change Password
.
Enter the same number again in
Confirm Password
to confirm the password.
Set ID Setup
Set ID Lock
Set ID
Auto Set ID
Reset ID
Press OK
No
OK
Previous
Press OK
1
S/W : xx.xx.xx.xx Micom : x.xx.x
OK
Installation Menu (V 3.0)
LG Digital Signage Setup
USB Cloning
Password Change
Set ID Setup
Configuration Setup
Lock Mode
Fail Over
SuperSign Server Setup
Easy Brightness Control
Set ID Lock

You can enable Set ID Lock by selecting
Yes
or cancel Set ID Lock by selecting
No
.
Set ID

Enter a number between 1 and 255 (or 1 and 1000) for Set ID.
Auto Set ID

The Set ID of a product is automatically configured.
Yes No
Setting ID Automatically.
Do you want to start with 1?
(Current Set ID : 1)

If it is Yes, the Set ID of each set in a RS232C daisy chain is configured starting from 1.

If it is No, the first set in the daisy chain is configured first and the rest of the sets are configured se-
quentially.

Because Set ID cannot be decreased from the current value, it is recommended to execute Reset ID
before using the function.

The execution time may vary depending on the installation environment.

If automatically setting the Set ID is not completed normally, turn the product off and on and then try
again.

Selecting Yes/No only works in the initial monitors in the daisy chain.
(It may not work depending upon the model.)
Reset ID

Initialize the Set ID of a product.

Then, the Set ID of all sets in a RS232C daisy chain is set to 1.
(It may not work depending upon the model.)