Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
Interface Selection
• You can set communication with the connected OPS.
• DISPLAY: Enables communication with external devices via the serial port.
• OPS: Enables communication via the OPS connected to the product.
• Interface Selection is enabled only when the OPS kit is connected.
OPS Power Control
• You can control the power of the OPS.
• Disable: Disables the OPS Power Control.
• Sync (on): Synchronizes the power status of the monitor and the OPS only when monitor is on.
• Sync (on/off): Always synchronizes the power status of the monitor and the OPS.
• When you set the OPS Power Control feature to on, you must set the sustain Aspect Ratio of the PM Mode to off.
Multi Display Mode
• The Multi Display Mode function displays a video signal received from DP In either in single mode (SST: Single Stream
Transport) or multi-mode (MST: Multi Stream Transport) through DP Out.
• If it is On, the image of each display is displayed in multi-mode.
• If it is Off, the image of each display is displayed in single mode.
• The multi-mode is available in a PC supporting DisplayPort 1.2.
• Multi-mode can connect up to only four monitors. (at the recommended resolution.)
• When this function is used, your monitor may not work properly depending on the video card. Reboot the PC after
setting the function to Off for stable screen output when not in use.
• In case of using DVI/HDMI Input to DP Daisy Chain, please set 'Multi Display mode function' to off.
Power Indicator
• Changes Power Indicator settings.
• If set to On, the Power Indicator is turned on.
• If set to Off, the Power Indicator is turned off.
• While the product is turned on, the Power Indicator is lit for about 15 seconds regardless of whether it is set to On
or Off.
ENGLISH
11